资源列表
LCD-12864
- 液晶12864的实现程序，各种最基本得简单、容易明白的函数实现-LCD 12864 implementation process, a variety of basic as simple, easy to understand the function implementation
dk3cewen
- 基于MSC—51以及温度传感器DS18B20的程序。-Based on MSC-51 and temperature sensor DS18B20 procedures.
TWIMAX6953
- 用TWI接口控制MAX6953驱动4片5X7点阵显示器-with twi to control the max6953
mcu-UCOS
- 51单片机上移植UCOS，希望对大家有帮助-51 SCM transplantation UCOS, we hope to help
feisikaer----duoji
- 这个程序是对在飞思卡尔中舵机的使用 ，程序已经调试过的，一切正常-This program is the use of servos in Freescale, the program has been debugged, all normal
Led_4Mul4_Key
- 数码管显示与4*4键盘最好在IDE中编译-Digital display and 4* 4 keyboard in the IDE to compile the best
user_sdcard
- SD卡驱动 STM32底层驱动配置 SD卡协议 支持SD卡 多媒体卡 TF卡-SD card driver STM32 underlying driver configuration SD card protocol support SD card multimedia card TF card
D12_DRV
- USB接口芯片D12在STC单片机上的驱动开发，定义ENDPOINT0,ENDPOINT1和ENDPOINT2为管理通道、中断模式和批模式。压缩包中包含头文件和C文件，在keil C8.2下编译使用，hex文件约7KB。-D12 USB interface chip microcontroller in the STC driven development, ENDPOINT0 definition, and ENDPOINT2 ENDPOINT1 access to management, i
hardware_jbig
- 硬件jbig 压缩算法，注意：不是软件压缩哈，这个是嵌入式的程序-jbig hardware compression algorithm, attention : No compression software Kazakhstan, this is the procedure Embedded
jishiqi
- 利用51单片机通过红外壁障模块做了一个定时器，利用数码管显示，精度非常高，可以用在小车测速上-51 microcontroller by infrared barrier module a timer, digital tube display, very high accuracy, and can be used in the car tachometer
menling
- 当按下QX-MCS51上的S2键后，蜂鸣器会发出十次短暂的“嘟嘟”声作为呼叫。 S3用于关闭或者打开门铃。 当门铃处于关闭时，按下S2不会有呼叫效果。-When you press the S2 key on the QX-MCS51, beeper ten times short " beep" as a call. S3 is used to close or open the door. When the door is closed, press S2
DianZhen
- 这个是在51上驱动点阵左右流动显示的源码，采用的是驱动硬件是595。-This is about mobile display driver dot matrix 51 on the source, using the drive hardware is 595.