资源列表
ads1210_C(F020)
- 用C8051F020驱动的ADS1210程序,可以控制误差在低8位以内(具体没算),程序已经完全经过调试通过
DS12C887calendar-clock-display
- 第14章 基于DS12C887的实时日历时钟显示系统设计-Chapter 14 DS12C887-based real-time calendar clock display system design
serial-port
- 基于单片机的串口发送接收，KEIL文件。简单实用-Microcontroller-based serial transmit and receive, KEIL file. Simple and practical
1302
- 1302做的时钟电路，可以用来做万年历的程序，-1302 to do the clock circuit, the procedure can be used for calendar,
3-29test
- 初学单片机,自己写的max7219驱动八位数码管程序,条理清晰,结构简单-Beginners microcontroller, wrote in max7219 drive eight digital tube program, a clear and organized, the structure is simple
I2C
- 基于单片机MSP430的iic存取程序。
18B20-digital-pipe-display-
- 温度传感器18B20数码管显示(加详释)(关于郭天祥老师TX-1学习板程序) -18B20 digital display temperature sensor (plus explaining) (TX-1 for Guo Tianxiang learning board Teacher Program)
DAC0
- 本例直接采用应用笔记案例.实现DAC模拟信号输出，由T4定时控制DAC0输出DTMF信号-Application note in this case by case directly. Realizing DAC analog signal output from the T4 output DTMF signal timing control DAC0
TLC2543
- TLC2543电压采集程序C51,已经通过程序测试-TLC2543 voltage acquisition program C51, has been tested through the program
LED164new
- 该程序主要实现通过74ls164实现串行驱动LED并显示,这种显示方法的LED量度较大-the main procedures adopted 74ls164 Serial LED driver and showed that This method showed a larger measure of LED
FW144PBootloaderHEX
- PIC18F458 firmware for tool using as diagnostic for car. Just re-flash the PIC and that s all. everything in.
timer
- 此程序额为msp430的定时器程序源码，大家使用时只需根据需要适当修改就可以了。-This program amounted msp430 timer program source code, we use only the appropriate modifications can be necessary.