资源列表
LCD1602
- 51单片机相关例程 LCD1602显示+串口接收温度- 51 SCM related routines LCD1602 display+ serial port to receive the temperature
USB2.0
- 很不错的usb规范ppt，做usb驱动的同学可以看看，比看书好多了。-Very good usb specification ppt, do usb drive the students can look at, than reading better.
windmotor
- 本设计介绍的是直流无刷电机的正弦波控制方式，以及基于英飞凌 XC866单片机的三相带霍尔传感器直流无刷风机 180 度控制方案。三相带霍尔传感器直流无刷风机 180 度控制系统主要由以下几大部分构成：整流电路、逆变电路、控制电路、驱动电路、开关电源、直流无刷风机及扇叶负载。-Is the design of the brushless DC brush motor sine wave control mode, and based on three-phase Infineon xc866 mi
STM32-SPWM
- stm32产生spwm程序，利用TIM1和DMA，通过PA8和PB13输出spwm波-stm32 produce spwm program, using TIM1 and DMA, and PB13 through PA8 spwm wave output
stm32例程
- stm32时钟与串行口通信，直接能运行的代码，十分详细(STM32 clock and serial port communication)
wendu
- 温度传感器，可以读取温度传感器数据，在液晶上面显示，直观方便。(Temperature sensor, you can read the temperature sensor data, displayed on the LCD, intuitive and convenient.)
BH1750程序
- 通过使用STM32F407，和1750光照传感器，实现对光照度数据的采集(The illumination data acquisition is realized by using STM32F407 and 1750 light sensors.)
lcd_dht11
- 通过dnt11采集环境温湿度，并能够在野火stm32minni板子的屏幕上显示。-Through the dnt11 collection of environmental temperature and humidity, and can be wildfire stm32minni board screen display.
111111
- 基于单片机的四路开关控制器的设计，并用LED数码管实时显示-Microcontroller-based design of the four-way switch controller and real-time display LED digital tube
D8-card-reader-test-for-vc6.0
- 德卡D8读卡器C#测试程序，用于测试与D8读卡器的通信，实现了读卡器的初始化，蜂鸣，密码校验和读写卡操作。-A test program for D&C s D8 card reader, it is used to test the communication with the D8 reader, and it has achieved the operation of the Initialization, beep, password checking reading and w
CVImageProcess
- 使用visual C++对.pic文件进行解码与读入。-Using visual C++ 对. Pic file to decode and read.
睡眠模式测试程序
- STM32之睡眠模式测试程序，适合于入门爱好者(STM32 Sleep Mode Test Program, Suitable for Beginner Enthusiasts)