资源列表
MultiFuncTool-code-
- 基于LM3S811多功能手持终端，可实现电压，电容，电感，频率的测量-Based LM3S811 multi-function handheld terminals, voltage, capacitance, inductance measurement
ESAM-IO-MCU
- ESAM芯片故障分析，监控电能表ESAM IO的口的数据，并进行解析- The ESAM chip fault analysis, the monitoring electrical energy table ESAM IO mouth data, and carries on the analysis
8-x-8-dot-matrix-scroll-design
- 51单片机做的8乘8点阵滚动设计，有仿真文件-51 microcontroller do 8 x 8 dot matrix scroll design, there are simulation file
VC_UsbReader_TestDemo_V10
- PCSS读写器DEMO工具VC源码。学习参考。-VC++ PCSC reader Demo code
output-based-on-SM32
- STM32输出固定的pwm，可以通过调节pwm波的频率及占空比的，用的主要是定时器的多通道。 -STM32 output fixed PWM, can regulate the frequency and duty cycle of the PWM wave, the main use of the multi channel timer.
timer
- 这个代码中，我们用用计数器0来作为一个信号捕捉的端口。当在P3.4端口采集到下降沿的时候，会在数码管上加1.（P1.0连接到P3.4)在程序代码中，我们给了P1.0端口，进行 一个赋值，让它电平交替变化。每变化一次，数码管的值就会加1。-In this code, we use counter 0 as a signal to capture the port. When the P3.4 port to capture the falling edge of time, will increa
DA-AD
- 我们单片机去控制PCF8591T去实现DA功能。这个代码也要在示波器上才能观测到，DA输出一个正弦波。-We have to control the PCF8591T microcontroller to achieve DA function. This code can also be observed on the oscilloscope, DA output a sine wave.
sd
- 这里需要用到2G的SD卡，SD卡插上后，会在串口中对数据进行读写,显示0-9-It should be used in 2G SD card after the SD card plugged in the serial read and write data, display 0-9
DS18B20LCD
- 这是通过51单片机实现温度采集功能的源码，希望可以给大家带来帮助-This is to achieve the temperature acquisition source by 51 microcontroller, hope can give us some help
stm32f4test_LCD
- stm32f4单片机裸机开发，其中的LCD的驱动及显示程序，包括串口和温湿度传感器。-Stm32f4 bare metal development, drive and display program the LCD, including the serial port and the temperature and humidity sensor.
AutoDoor
- C51自动关门开门程序，结合无线控制和GSM模块-C51 automatic door closing procedures, combined with wireless control and GSM module
AdjBrl
- C51控制呼吸灯周期可调节并用数码管显示-C51 control of respiratory lamp cycle can be adjusted and digital display