资源列表
RFPCBdisign
- 有关射频PCB设计的一份资料，很不错的，欢迎下载-Of RF PCB design information in a very good welcome to download
PCBstandard
- 这是一份讲述PCB设计规范的一份资料，写的很好，很实用-It is a norm on a PCB design data, to write a good, very practical
ECG
- ECG设计流程，包括构思，芯片选择，电路图，电路仿真，程序编写等。-ECG design process, including concept, chip selection, circuit diagrams, circuit simulation, and other programming.
19_SD_Card
- 这是基于arm9嵌入式微处理器s3c2440a，由广嵌开发的gec2440开发板上的sd卡的源程序，里面注解详细！-This is based on the arm9 Embedded Microprocessor s3c2440a, developed by the widely embedded development board gec2440 the source of the sd card, which notes in detail!
LC_rar
- 基于AT89S52的单片机温度时钟系统的原理图 很实用 是单片机实习的一个作品 -AT89S52 microcontroller-based temperature clock system is very useful schematic of a single-chip attachment works
DS18B20
- 单片机的温度显示系统设计文档，主要说明了用DS18B20设计的系统-Single-chip temperature display system design documents, mainly describes the design of the system with DS18B20
signal
- verilog写的串口控制信号发生器，能通过用串口控制产生正弦波方波等信号-written in verilog serial control signal generator, can be generated using serial control, such as sine wave square wave signals
13706_Linux_v2_1
- S1D13706是驱动TFT彩屏的控制器IC，功能强大。linux下驱动代码-S1D13706 is a color TFT controller driver IC, a powerful. driver code under linux
SCANTest
- scan算法用 实现的算法 实现的算法 实现的算法 -scan in English English English English English English English English English English
clock
- 要求以MCS-51系列单片机为核心设计一个多功电子表，具有电时钟和跑表功能。做时钟时在4位LED 显示器上显示分、秒，做跑表时显示范围000.0秒~999.9秒并具有跑表启动和跑表复位功能键。电子时钟的计时范围00分00秒59分-59秒，并在4位LED 显示器上显示；做跑表时显示范围000.0秒-999.9秒，当按下启动按钮跑表开始计时，按下停止按停止计时，当按下复位按钮跑表回零。-Request to MCS-51 series single-chip microcomputer as the
51MCURTX
- 单片机红外数据通信系统