资源列表
IntelligentMultiF310Li-ionbatterymanagementprogram
- 基于F310只能多功能锂电池充电器设计方案-Can only be based on multi-F310 Li-ion battery charger design
C8051FmcuRadiofrequencycardreaderprogram
- C8051F单片机RFID无线射频读卡方案-C8051F single-chip radio frequency RFID reader program
ez430-f2013
- msp430-f2013单片机的评估板（usb接口的）例程，c语言，包括多个程序，帮助您使用该单片机-msp430-f2013 MCU Evaluation Board (usb interface) routines, c language, including a number of procedures to help you use the single-chip
PROTEUSchinesejiaocheng
- Proteus中文教程,作为一个极为优秀的软件,教程却很少,本教程很珍贵-Proteus Chinese course, as a very good software, very few tutorials, the course is very valuable
picusbcombo
- pic单片机usb串口通讯示例源程序，可直接应用pic18系列-Single-chip serial communication pic sample source usb direct application pic18 series
qw
- 单电源供电的电路（图一中右）运放的电源脚连接到正电源和地。正电源引脚接到 ... 单电源工作的运放需要外部提供一个虚地，通常情况下，这个电压是VCC/2，图二-Single power supply circuit (Figure 1 right) foot power operational amplifier connected to the positive supply and ground. Supply pins are received ... the work of single
atmega16lc
- 本设计选用第三种方案，用PMM8713三相或四相步进电机的脉冲分配器、SI-7300A两相或四相功率驱动器，组成四相步进电机功率驱动电路，以提高集成度和-The third program of this design choice, and PMM8713 or three-phase four-phase stepper motor pulse distributor, SI-7300A Two-phase or four-phase drive power to form a four-p
qw
- 原创 单片机教学打铃控制器C语言 收藏. /* 湖南师范大学工学院课程设计 单片机教学打铃控制器 芯 片：AT89S52 晶 振：频率12MHz 按键说明： BellSet P1^0//时间设置 ... -Original single-chip controller Darlin teaching collection of C language.Institute of Technology, Hunan Normal University, teaching courses desig
picsrlbootl
- pic单片机srlbootload源文件参考-pic source srlbootload single-chip reference
tasksystem
- 一个简单的单片机多任务操作运行实例 （uVISION 工程）-A simple single-chip operation of multi-tasking to run examples
danpianjilvbojingdian
- 单片机各种软件滤波源码,包括限幅滤波,中值滤波,算术平均滤波,递推平均滤波等等数种源码,珍贵资料-Single-chip filtering software source code, including limiting filtering, median filtering, arithmetic mean filtering, recursive filtering, etc. The average number of source, valuable information
CANzongxianjigndian
- Can总线接口通信设计,包括电路和源码,强烈推荐-Can Bus Interface communication design, including circuit and the source is strongly recommended