资源列表
caidanchengxu
- 简单的单片机多级菜单程序,这是个通用程序，需要的话可以自由编写。-jian dan duo ji cai dan.
key
- 键盘扫描完整c程序，并带有数码管显示，可以实现加一，减一，复位等功能。-C program to scan the full keyboard and a digital display, plus one can be achieved, by a reset functions.
traffic
- 交通灯演示c程序，采用定时器实现计时，与交通灯演示delphi程序配套-C procedures for demonstration of traffic lights, using timers to achieve time, with traffic lights delphi demo program package
serialforavr
- 主要是配合avr单片机的一个测试程序,里面有串口通讯,和listiew潜入控件-Mainly avr microcontroller with a test procedure, there are serial communications, and control into listiew
max232
- max232与上位机通信程序，带有数码管显示-max232 with the host computer communication program, with digital display
AVRmonitaor
- 本文档用于描述一体化组合模块485监控板监控对象，以及单片机实现功能的简单概述。-This document is used to describe the integration of portfolio monitoring board monitoring module 485, as well as the function of single-chip realization of a simple overview.
waveform_generator_design
- 基于单片机的结晶器液压振动波形发生器的设计—上位机部分-The crystallization of single-chip microcomputer-based hydraulic vibration waveform generator design- part of host computer
C05_LCD
- C05_LCD，LCD的DB0-7,RS,R/W,E与MCU的普通I/O口引脚连接，MCU的串口与PC方的串口相连，MCU接收PC发来的32个字符,并送LCD显示-C05_LCD, LCD the DB0-7, RS, R/W, E and MCU general I/O port pin connection, MCU and the serial port connected to PC' s serial port, MCU sent PC to receive the 32 cha
C19_uCOS-II_SCIShineLED
- 本程序实现的硬件平台为苏州大学MCU&DSP研发中心的MC9S12DG128核心板与MT-ExBorard-Ⅰ型扩展板。该硬件平台使用9.8304MHZ的有源晶振，配置后系统程序运行的总线频率为4.9152MHZ。硬件连线方面，使用扩展板下方的10到17脚即标识为LED1_LD0至LED1_LD7的引脚连接8盏小灯；板上SCI1连接PC的串口，通信波特率为9600。 在这个实例中，我们利用PC机串口发送的一个字节数据来控制八盏小灯的闪烁。 -This procedure for the
pidc_control
- 基于MC9S12DG128的PID控制，采用整形运算，A口输出结果-MC9S12DG128 based on the PID control, the use of plastic surgery operations, A port output
LCD_display_control
- 点阵LCD的驱动显控原理，以MzL02LCD模块为例讲述LCD的工作驱动原理-Dot-matrix LCD Display and Control Principles of the drive to MzL02LCD on the LCD module as an example the work of driving principle
AD9851_C51
- AD9851:本程序实现了用51单片机串行控制AD9851的DDS芯片输出频率可变的正弦波信号.-AD9851: this program with 51 single-chip serial control of the DDS chip AD9851 variable frequency sine wave output signal.