资源列表
main
- 飞思卡尔单片机的sd卡程序，型号MC9S12XS.-Freescale microcontroller sd card program, model MC9S12XS.
TFT
- TFT屏 用IC ILI9486 的初始化代码-inital for ILI9481 driver
毕业论文
- 本文具体介绍了怎样利用Intel公司的8051单片机设计和实现一款低成本的可配置性的单路电话计费器。-This article describes how to make use of specific Intel s 8051 Design and Implementation of a low-cost configurability of one-way billing phone browser.
Apnt_154
- keil 资料-keil information
xlbh
- 基于C51体系结构实现的电路保护的源代码，有非常珍贵的商业价值-C51-based architecture to achieve circuit protection of source code, has a very valuable commercial value
如何为keil c51写自己的仿真dll
- 如何为keil c51写自己的仿真d-Keil c51 how to write their own simulation d
pcfs
- 基于AVR的万年历，PCF8563实时芯片，12864显示，按键控制，闹钟报警-AVR-based calendar
avr-c-rotate
- MCU:AVR , Compiler:CodeVision(C) , How to get an input value on one port and rotate it on other port
TLC5618
- 51单片机控制12位DA芯片TLC5618产生锯齿波，可作为扫频的触发信号-51 SCM 12 DA chip TLC5618 generated sawtooth sweep trigger signal can be used as
fengmingqi
- stc89c52单片机驱动蜂鸣器的程序，延时函数用定时器方式编写。-stc89c52 MCU-driven buzzer procedures, with the timer delay function approach to the preparation.
LCD1602(lm3s9b92)
- lcd1602驱动程序，主芯片采用LM3S9B92，本程序提供了lcd1602的初始化，写数据函数-lcd1602 driver, the main chip LM3S9B92, this program provides lcd1602 initialization, write data function
led
- 16键码显示的程序,我们在P1端口接一支共阴数码管SLED，在P2、P3端口接16个按键，分别编号为KEY_0、KEY_1到KEY_F，操作时只能按一个键，按键后SLED显示对应键编号。-16 key code shows the procedure, we take a total of P1 port overcast digital tube SLED, at P2, P3-port access button 16, respectively, numbered KEY_0, KEY_1