资源列表
STM8L
- IAR开发环境，STM8L单片机，Att7053计量芯片，此仪表程序可以显示电压电流频率-IAR development environment, STM8L SCM, Att7053 measurement chip, the instrument can display the voltage and current frequency of program
0-999_count
- 51单片机程序，0-999计数器，配有实验说明文档。-51 ,0-999 MCU program counter, with experimental documentation.
TIchinese_M188
- 用MSP430F149做TCP/IP通讯(含线路与源码) -MSP430F149 do TCP/IP communications (including line source)
jlinkv8
- Jlink调速器烧写工具,包括jlink.bin-Jlink emulator tools
24C16
- 基于单片机的外部数据存储器AT24C16的数据参数-Based on AT24C16 microcontroller external data memory data parameters
base_project_for_stdlibv3
- 本例程主要介绍ARM Cortex M3 STM32的使用，工程的创建。-ARM Cortex M3 STM32 use, including project creation, ADC, timer, PWM output routine testing procedures in addition to the Ethernet.
door
- 采用430单片机完成的门禁控制器程序，基于电总协议。利用单片机自身的FLASH进行记录卡号和信息。-MSP430 single chip using the Access Controller to complete the procedure, based on the General Agreement on electricity. The use of single-chip FLASH recorded their number and information.
UART_TEST
- 单片机串口通信程序，可实现主机与单片机的实时通信-Single-chip serial communication program can be realized with single-chip host of real-time communication
SVPWM_main
- TI的2407产生SVPWM的参考资料,tma320f2407-c
AT89S52
- 一个基于at89s52单片机的完整程序，包括步进电机驱动，基于SED1520的122*64液晶显示，键盘扫描的完整程序，我运行过了-At89s52 based on a complete single-chip process, including the stepper motor driver, based on the SED1520 122* 64 LCD display, full keyboard scanning process, I had to run
P10
- 本程序是16*32点阵测试用程序，稍做修改便可以使用。主要方便学习和自制LED点阵用。-Lattice test procedures, minor changes can be used.
can
- pic18 系列单片机，CAN配置模板。 //设置对CAN进行配置 /* ***********波特率设置 ************************** */ //设置CAN波特率1Mbps，在Fosc=32MHz时，Tbit=0.125us，假设BRP=01H //则Tq=[2*(1+BRP)]/Fosc=2*(1+1)/(32MHz)=0.125us //normal bit rate=8Tq，SJW=00,Sync_Seg=1Tq,Prog_Se