资源列表
单片机实验二
- 1.将P1.0～P1.3接开关，将P1.4～P1.7接发光二极管。依据P1.0～P1.3开关状态控制P1.4~P1.7发光二极管点亮。 2.将P1.0～P1.7全部接发光二极管，开始P1.0、P1.5点亮，左循环50次后P1.1、P1.4点亮；右循环30次，循环往复。-1. P1.0 - P1.3 will then switch to P1.4 - P1.7 access LEDs. P1.0 - P1.3 based on state control switch P1.4 - P1.7 L
单片机实验三
- P1.7～P1.0接发光二极管L8～L1，要求利用单片机内部定时器1，按方式1工作，每0.01秒T1溢出中断一次。要求编写程序模拟时序控制装置。开机第1秒钟L1、L3亮，第2秒钟L2、L4亮，第3秒钟L5、L7亮，第4秒钟L6、L8亮，第5秒钟L1、L3、L5、L7亮，第6秒钟L2、L4、L6、L8亮，第7秒钟8个发光二极管全亮，……一直循环下去。fosc=11.0592MHz-P1.7 - P1.0 then LED L1 to L8, by using a timer internal mi
USB118TH
- usb host读写U盘！-usb host U-reader!
sdcc-2.4.0.tar
- Small Device C Compiler 面向Inter8051，Zilog Z80,Dallas 80C390,Motorola HC80等系列单片机的开源C编译器，针对上述产品进行了优化--Small Device C Compiler. It is an open source C compiler for Inter8051, Zilog Z80, Dallas 80C390, Motorolas HC80 and other SCMs.
vp12864
- 精电的12864驱动原码，asm和c.-Varitronix drive the original 12,864 yards, and c. asm
huayangANGLE
- 花样任意角度旋转-Synchronized arbitrary rotation angle
8ic
- ic驱动控制程序-ic-driven control program
1601Lcd
- 52下1601液晶驱动程序-52 LCD Driver
armok012542
- AVR单片机软件模拟USB的程序。-AVR USB software simulation procedures.
压力测量与精度分析
- 基于转换器的压力测量与精度分析-converters based on the pressure measurement and analysis accuracy
用软件执行I2C总线的控制功能的方法 说明及源程序
- 用软件模拟I2C的源代码，内有说明-I2C software simulation source code, which is described
led广告屏
- 这是“led广告屏”程序，已经成功调试，希望对大家有用，谢谢！（最好配合51单片机和伟福编译器）-"led advertising screen" program has been successfully tested and we hope to useful, thank you! (Preferably with 51-fu SCM and compiler)