资源列表
M62429
- 本程序是在单片机上编写的一个驱动M62429音效IC的C程序，本人已测试过OK！-M62429 C
BLDC_Sensorless_FOC
- BLDC sensorless代码，可供学习参考用-BLDC sensorless code for study
mage8_rx
- Frequency hopping spread spectrum receiver using si4432 and atmega8, 50 channels 20ms hop time
si4432_tx_example
- Frequency hopping spread spectrum transmitter using si4432 and atmega8
hongwaiyaokong
- 这是基于52单片机的红外遥控的基本代码，单片机通过接收红外线码，然后再解码，读出红外信号。-This is based on 52 single-chip infrared remote control of the basic code, the microcontroller through the infrared code to receive, and then decode, read out the infrared signal.
SD18D20
- 编程使QX-MCS51开发板的数码管能正确的显示DS18B20转换的正温度值和负 温度值（转换精度为12位模式）。-Programming QX-MCS51 development board of the digital tube can correctly display the positive temperature and negative DS18B20 conversion Temperature value (conversion accuracy of 12 bit m
shumaguanxianshiDS1302shizhong
- 以51单片机为处理器来计时，通过控制数码管的显示来显示DS1302时钟。-With 51 single-chip microcomputer as the processor to time, by controlling the display of digital tube to display the DS1302 clock.
1602xianshiDS1302shizhongrili
- 通过单片机的定时计数和显示功能，把DS1302时钟在lcd1602液晶屏中显示出来。-Through the microcontroller timer count and display function, the DS1302 clock in the LCD1602 LCD screen display.
shumaguandongtaixianshi
- 利用定时器1，定时60秒让数码管的最右边2位实时的显示出来，到60秒关闭数码管显示，让LED流水灯从左到右循环移动。 -Use timer 60, timer 1 seconds to the right of the digital control of the 2 real time display out, to 60 seconds off the digital display, so that the LED water lamp left to right loop mobi
USART3
- 基于stm32 串口3 usart3 支持窗口printf打印-Based on the STM32 serial port 3 usart3 support window printf printing
zhongduanxitong
- 使用定时器1中断让8个LED循环右移，间隔500ms，同时使用定时器0中断方式 让数码管前2位间隔1000ms从0显示到60,如果有外部中断产生则停止数码管走数. （外部中断0低电平触发方式） -Use timer 1 interrupt let 8 LED right, 500ms interval, at the same time using timer 0 interrupt mode Let the digital control of the top 2 interv
I2cchuankoutongxin
- 往QX-MCS51开发板的AT24C02内任意一个单元写数据，开发板上电后首先读取此单元的原有的数据，然后赋给程序中的计数变量，计数变量再以5秒的速度+1并且写入AT24C02，当计数大于99时清零再写，用数码管显示。-To QX-MCS51 development board AT24C02 arbitrary a unit to write data, development board after the first read the original data of the unit a