CDN加速镜像 | 设为首页 | 加入收藏夹
当前位置: 首页 源码下载 嵌入式/单片机编程 单片机(51,AVR,MSP430等)

资源列表

« 1 2 ... .29 .30 .31 .32 .33 1534.35 .36 .37 .38 .39 ... 15288 »
  1. baiduring

    0下载:
  2. 百度智能运动手环,包括硬件设计、通讯协议、测试demo-Baidu intelligent motion bracelet, including hardware design, communication protocols, test demo
  3. 所属分类:SCM

    • 发布日期:2017-06-10
    • 文件大小:16.44mb
    • 提供者:Julius
  1. MTR4046

    0下载:
  2. MTR4046,MRT_SAM二代证方案硬件设计,设计相关文档及芯片手册,身份证号码真伪检验程序及上位机-MTR4046, MRT_SAM second generation ID card scheme hardware design, chip design-related documents and manuals, identity card number and the authenticity of test procedures PC
  3. 所属分类:SCM

    • 发布日期:2017-05-07
    • 文件大小:1.15mb
    • 提供者:Julius
  1. 2660

    0下载:
  2. 淘宝买的,很好用的RTD2660程序淘宝买的,很好用的RTD2660程序-Taobao to buy, easy to use RTD2660 programTaobao to buy, easy to use RTD2660 program
  3. 所属分类:SCM

    • 发布日期:2017-05-16
    • 文件大小:3.6mb
    • 提供者:徐万勇
  1. chuankoutongxin

    0下载:
  2. msp430f149计算机串口通信,串口通信程序-MSP430F149 serial communication
  3. 所属分类:SCM

    • 发布日期:2017-05-01
    • 文件大小:46.52kb
    • 提供者:黄翰林
  1. daojishi_miaobiao

    0下载:
  2. 倒计时秒表设计:使秒表在上电/复位后,具有:开始时显示 9.9 ;并开始倒计时, 当9.9S计时到,数码管显示0.0并闪烁,同时蜂鸣器发声报警3S,倒计时误差小于0.2秒。 晶振频率:11.0592MHz-Countdown stopwatch design: stopwatch after power-on/reset, comprising: a display at the beginning of 9.9 and begins the countdown, When t
  3. 所属分类:SCM

    • 发布日期:2017-04-12
    • 文件大小:1.17kb
    • 提供者:张平华
  1. stopwatch

    0下载:
  2. 数码秒表设计:开发板上4键从左至右为S1-S4,上电后,开始时显示 0.0 ; 利用S1按键后启动计时;S2按键后停止计时;S3按键后计时归零;最大计时 为9.9秒。计时误差小于0.2秒,显示稳定。 晶振频率:11.0592MHz -Digital stopwatch design: 4 key development board left to right S1-S4, after power is displayed at the beginning of 0.0 S
  3. 所属分类:SCM

    • 发布日期:2017-04-12
    • 文件大小:1.13kb
    • 提供者:张平华
  1. xinhaofashengqi

    0下载:
  2. 按下S1从单片机第1个引脚上输出频率为1KHz的方波,再按下S1则停止输出方波; 方波频率误差小于1 。 晶振频率:11.0592MHz-Press S1 output the first one on the microcontroller pins 1KHz square wave frequency, and then press the square wave output S1 is stopped Square-wave frequency error is less
  3. 所属分类:SCM

    • 发布日期:2017-04-12
    • 文件大小:852byte
    • 提供者:张平华
  1. pinlvji

    0下载:
  2. 频率计在上电后,具有:能测试1-100HZ的低频信号;并把结果显示在数码管上。误差小于1HZ。-After power-frequency meter, comprising: a low-frequency signal to test the 1-100HZ and the results are displayed on digital tube. Error is less than 1HZ.
  3. 所属分类:SCM

    • 发布日期:2017-04-12
    • 文件大小:1.09kb
    • 提供者:张平华
  1. LED_controlled_by_keys

    0下载:
  2. 程序实现如下模拟彩灯,开发板从左至右4个按键分别为S1-S4,从上至下8个灯为L1-L8,按下S1键8只LED小灯以1HZ频率闪烁,按下S2键8只灯奇偶交替点亮,间隔0.3S,按下S3键,L1-L4与L5-L8灯交替点亮,间隔0.2s,按下S4键熄灭所有灯。-Lantern simulation program to achieve the following development board left to right are four buttons S1-S4, top to bot
  3. 所属分类:SCM

    • 发布日期:2017-04-12
    • 文件大小:1.33kb
    • 提供者:张平华
  1. 1302

    0下载:
  2. 1302的使用,包含测试1302激活的函数,包含基本的使用-use 1302
  3. 所属分类:SCM

    • 发布日期:2017-04-14
    • 文件大小:2.7kb
    • 提供者:张题
  1. HIGHT-osc

    0下载:
  2. 这是个高精度的信号源,能够实现正弦波,可控占空比的方波等幅度和频率都可以调节的实物代码。决对可行。-This is a high-precision signal source, it is possible to achieve a sine wave, controlled duty cycle square wave amplitude and frequency can be adjusted physical code. Absolutely feasible.
  3. 所属分类:SCM

    • 发布日期:2017-04-30
    • 文件大小:496.48kb
    • 提供者:王荣成
  1. LEDdengcontrol

    0下载:
  2. 这个是LED智能灯的控制,是我为别人毕业开发的整套程序,能够实现灯的节能智能化控制,有具体实物,决对可行。-This is to control the LED lights intelligent, I graduated for others developed the entire procedure, to achieve energy-saving lamps intelligent control, with specific objects, absolutely feasible
  3. 所属分类:SCM

    • 发布日期:2017-05-09
    • 文件大小:1.8mb
    • 提供者:王荣成
« 1 2 ... .29 .30 .31 .32 .33 1534.35 .36 .37 .38 .39 ... 15288 »
搜珍网 www.dssz.com