资源列表
pic-pulse
- 这是几个基于PIC16F877A，PIC16F636/676的用于计时仪表，设备控制，用MPLAB IDE编写的C语言程序。-This is a few PIC16F877A, PIC16F636/676 for timekeeping instrument, device control, written in C language program using MPLAB IDE.
4*4键盘扫面 proteus仿真文档
- 4*4键盘扫面 proteus仿真文档，内附汇编和C两种编写程序，适合初学者阅读-4* 4 keyboard sweep surface proteus simulation documentation included assembler and C are written in both procedures, suitable for beginners to read
Dual-SCM-communication
- 两块AT89C51通信，汇编语言代码，不是C编译的，代码较少，适合初学者学习-Two AT89C51 communication, assembly language code, not the C compiler, the code is less suitable for beginners to learn
AD-conversion
- AD0832 PROUEUS转换仿真文档，内附完整源码，适合初学者学习-The the AD0832 PROUEUS conversion simulation documentation included with complete source code, suitable for beginners to learn
Signal-waveform-generator
- 信号波形发生器，内附proteus仿真工程及VsinTab正弦波表生成器-Signal waveform generator included proteus simulation the engineering and VsinTab sine wave table generator
STC89C52PDS18B20PSEG
- 基于单片机STC89C52的温度测控系统,系统温度信号由温度芯片（如DS18B20）采集，并以数字信号的方式传送给单片机，对温度信号进行处理，并通过八段数码管显示。本设计要求设计相关的软硬件系统，要求系统可实现一定范围内（采用DS18B20时温度测量范围－55～＋125℃）的温度检测和控制，精确度要求达0.1℃。包含Proteus仿真原理图和PCB板图、以及调试通过的源程序。 -Based the microcontroller STC89C52 temperature measuremen
c8051f020Pprinter
- c8051f020高端单片机和微型打印的驱动源码。直接可以用买的开发板里面带的-c88051f020 high-end microcontroller and micro-print driver source code. Can be used directly with the development board inside buy
1.8寸tft简单显示
- ST7735驱动IC,1.8寸tft简单显示-The ST7735 driver IC, 1.8 inch tft simple display
shuzimimasuo
- 数字密码锁的设计，6位密码，可设置新密码，错误报警-Design of digital code lock 6 password, you can set a new password, false alarms
Timer-interrupt
- 51定时器中断 程序 51定时器中断 程序-Timer interruptTimer interruptTimer interruptTimer interrupt
The-51-MCU-matrix-key-procedures
- 51单片机矩阵按键程序 -The 51 MCU matrix key procedures
NumberDisplay
- AVR proteus NumberDisplay 按键 硬件图-The AVR proteus NumberDisplay key hardware chart