资源列表
KB1
- 开发环境IAR,利用C语言实现扫描4X4键盘,当有键按下被识别以后蜂鸣器鸣响一声，并将键值在数码管和8个LED上显示,同时将键值通过串口发送给PC机-Development environment IAR C language to achieve scan 4X4 keyboard when the key is pressed the buzzer sounds loudly to be identified, and key digital tube and eight LED displ
I1
- 开发环境IAR,C语言实现，将USB口接收到的数据通过串口转发出去-Development environment IAR C language, the USB port received data is forwarded out through the serial port
AA1
- 利用C语言编写代码，控制MSP430实现AD转换。开发环境：IAR FOR MSP430-C language to write code, AD converter control MSP430. Development environment: IAR FOR MSP430
CGM12864CFAA
- CGM12864CFAA test code in keil c.
23LED_wnl
- S52 DS1302 18b20 共阴LED数码管显示温度时间，有闹铃功能，23位数码显示。-S52 DS1302 18b20 common cathode LED digital tube display temperature alarm function, 23 digital display.
stepmoto
- 步进电机升降速控制程序，采用阶梯方式升降速，驱动57BYGH503步进电机，每分钟可达460转。-Stepper motor lift speed control program, using a stepwise manner lifting speed, drive 57BYGH503 stepper motor, up to 460 revolutions per minute.
1602
- 1602液晶程序，在AVR等单片机中的应用例子，有详细的代码说明。-1602 C
Temperature-relay
- 基于51单片机的温控继电器 程序 大家可以根据程序 简单了解原理-51 microcontroller-based temperature control relay program simple to understand the principle according to the program
jishu
- 计数器，数码管从0到9依次显示，一个周期后重复-Counter, digital tube display from 0-9 followed by a cycle repeated after
AT24C02c
- 按键测试I2C存储芯片 AT24C02C 编译硬件测试通过，使用普中科技开发板，我的毕业设计板子 -I2C EEPROM test pass you can use it.
LCD12864
- 点阵式LCD12864接口与程序设计分析-Dot-matrix the LCD12864 interface with program design and analysis
hongwai
- 红外遥控测试程序，用于51单片机实验板测试程序-Infrared remote test program for 51 single-chip board test program