资源列表
lcd1602
- Atmega128l连接1602显示屏的一个小实例-Atmega128l connected to a small example of the 1602 display
xinhaodeng
- 根据单片机编程原理实现对交通信号灯的控制-Control of traffic lights based on the principle of microcontroller programming
danpianji
- 利用定时器T1的模式2对T1引脚输入的外部信号计数，要求计满100个脉冲，将P1.0引脚取反。-External signal on T1 pin count of timer T1 mode requires the expiration of the 100 pulse P1.0 pin negated.
chuankou
- 用中断法编出串行口方式1下的发送程序。设单片机主频为6MHZ，定时器T1用作波特率发生器，波特率为2400b/s，发送字符块在内部RAM的起始地址为TBLOCK单元，字符块长度为LEN。要求奇校验位在数据第8位发送，字符块长度LEN率先发送。-Send serial port interrupt method to compile the program. Let microcontroller clocked at 6MHZ, timer T1 as baud rate generator,
AD
- 通过单片机实现A/D和D/A转换器正逆变换-MCU A/D and D/A converters are inverse transform
Speed
- 智能车速度控制程序 采用PID控制算法 -freescale speed
ATD
- 飞思卡尔XS单片机ATD转换资料，源代码，多路转换，单通道转换-freescale atd
My-ATD-Record
- 基于飞思卡尔XS单片机的全部AD转换驱动-Freescale AD
PID
- PID控制算法实现 基于飞思卡尔XS单片机-PID
NRF24L01
- 基于MSP430的NRF2401的测试程序。-Based the MSP430' s NRF2401 the test procedures.
uart_INT
- 在GT2440开发板上实现的基于中断方式的串口通信裸机程序，适合于初学者参考-GT2440 development board based interrupt bare metal serial communication program, suitable for beginners reference. . .
qiangdaqi
- 基于C8051单片机的抢答器设计源代码,工程文件夹-Responder design source code, based on the C8051 microcontroller project folder