资源列表
USB-TO-USB-TO-RS232-DRIVER
- ucb 转串口驱动，包涵大多系统版本的，保证驱动完好-ucb to serial driver it covers most of the system version, in order to drive intact
sy2
- 将8个按键从0-7编号，在1个数码管上显示相应的键号。如果按键改变，则显示也相应改变。-Eight keys from No. 0-7 in the corresponding key number is displayed on a digital tube. If the key change, the display can also be changed accordingly.
sy1(2)
- 按1次按键 ，1个LED闪烁；按2次按键，2个LED闪烁；按3个按键，3个LED闪烁；按4次按键，4个LED闪烁。继续按下按键，则LED全灭，如此循环。-Press the 1 button, an LED flashes press 2 buttons, two LED flashes press three buttons and three LEDs flashing press four buttons, four LEDs flashing. Continue to press
sy1(1)
- 每按一次按键，累计按键次数并通过LED显示出来，且采用16进制计数。-Each time you press the button, the cumulative number of keystrokes and through the LED display and hexadecimal count.
sy3
- 模拟锅炉恒温控制,温度高于设定温度就停止加热,温度低于设定温度就开始加热-Analog boiler thermostat control, the temperature is higher than the set temperature of the heating was stopped, the temperature is below the set temperature on the start of heating
sy1
- 模拟输入输出,输入电压,将电压值显示在数码管上-Analog input and output, the input voltage, the voltage value is displayed on the digital
MSP430Pcamera
- MSP430f149实现摄像头图像采集，通过串口发送数据到电脑上，可通过串口助手才看采集图像效果-MSP430f149 realize camera image acquisition, through the serial port to send data to the computer, but through the serial port assistant will see acquisition image effect
DS18B20
- 基于DS18B20的测温程序，通过液晶1602显示出来，实现实时的温度测量-Based on DS18B20 measurement procedures, LCD 1602 display, real-time temperature measurement
demo_led
- STM32 纯净工程。无其他外设，可作为stm32入门工程模板，官方最新固件库。-STM32 pure engineering. No other peripherals can be used as the stm32 starter project templates, latest official firmware library.
small_car_18
- 光电红外车入门程序。功能较全面。出自杭州电子科技大学-freescale car . LED by hangdian
M64_SD_MP3
- ATMEGA64的SD卡MP3程序ICCAVR-The MP3 program ICCAVR of ATMEGA64 SD card
DP83848-Ethernet-Board
- DP83848的以太网通信程序，LwIP的开源协议。-The the DP83848 Ethernet communication program, LwIP the open source agreement