资源列表
dianjitiaosu
- 基于msp430g2553的电机调速程序 很好用到的-Good to use based on the msp430g2553 motor speed program
bijiaoqi
- 基于msp430g2553的比较器程序 适合新手学习-Msp430g2553 comparison program for novice learning
12864xianshihanzi
- 12864显示汉字 内有protues仿真 基于51单片机-12864 kanji protues simulation based on 51 MCU
16x16dianzhen
- 16x16点阵完整原理图和程序 基于51单片机 没有protues 仿真图-16x16 dot matrix full schematic and not protues simulation program based on 51 MCU Figure
Volt-Acquire(slover)
- 单片机 ad转换 电压采集 串口 上位机显示 下位机程序-SCM ad conversion voltage acquisition the serial host computer display lower computer program
Contorl-PPT(slover)
- 单片机 红外 控制 ppt 下位机程序-SCM infrared control ppt lower computer program
diannaoshu
- 本人周立功电脑鼠大赛的二等奖源码C程序，稳定-I ZLG second prize of a computer mouse contest source C program, stable
stm8l15x_io
- ST低功耗MCR stm8l15x 标准固件库，对初学者入门很有帮助-ST' s low-power MCR stm8l15x standard firmware library entry helpful for beginners
100238c9y5ai1hvf8i7kf7
- 2.4寸液晶的51驱动程序。基本实例都包含在其中-51 2.4-inch LCD drivers. Basic examples are included in which
stm8
- 现在几乎所有的单片机都能用C语言编程了，采用C语言编程确实能带来很多好处，至少可读性比汇编语言强多了，这个资料主要包括stm8一些基础的程序，很容易使初学着入门-Almost all of the microcontroller can now use the C programming language, using the C programming language can really bring a lot of benefits, at least readable than ass
PLL
- 30MHz-200MHz PLL锁相环，硬件电路，控制程序，原理图使用ORCAD,PCB使用POWERPCB5.0，控制程序使用KEIL C-30MHz-200MHz PLL phase-locked loop, the hardware circuit, control procedures, schematics using ORCAD, PCB use POWERPCB5.0 control program uses KEIL C
series
- 串口通信，以前做实验时，做了很久。马上要毕业了，这么删除了，可惜-Serial communication, doing experiments to do for a long time. About to graduate, so deleted, but unfortunately