资源列表
UDP
- 周立功以太网udp例程，简单易学，适合初学者理解udp-ZhouLiGong Ethernet udp routines, easy to operate, is suitable for beginners understand udp
i2c
- LM3S的I2C程序，很有参考价值，特别是对新手而言。-LM3S the I2C program, great reference value, especially for the novice.
calcultor
- 用C51制作4*4的计算器仿真，显示用的是lcd1062.其中10及其以上的用的是16进制的ABCDEF表示-C51 produced 4* 4 calculator simulation, display lcd1062. 10 and above is hexadecimal ABCDEF
keybrd
- 这个是Ｃ５１的键盘扫描程序，扫面速度快。没有采用中断方式，把外部中断节约出来给其他用。-This is program of 16*16 keyboard about C51.Scanning speed.Not the interrupt mode.
MSP430UART
- MSP４３０的串口通讯程序。实现了串口的收发。-MSP430 serial communication program. Serial transceiver.
MSP430-RS232
- msp４３０实现RS２３２的串口通讯程序。-msp430 RS232 serial communication program.
MSP430_CAN_mpc2510
- 用MSP４３０设计的CAN总线通讯程序，收发芯片为２５１０.-CAN bus communication procedures, the transceiver chip MSP430 design for 2510.
wirelessshortT
- 8051单片机实现短距离的无线通讯，数据传输与接收。-8051 to achieve the short-range wireless communications, data transmission and reception.
DportRAMComm
- 在双口RAM的8051单片机之间的通讯，数据传输与接收。-Communications, data transmission and reception between the dual-port RAM 8051.
P-MPDataTRPro
- 8051单片机点对多点之间通讯，数据传输与接收。-Between 8051 point-to-multipoint communications, data transmission and reception.
zpd
- 步进电机零位检测，NEC DX2程序，用于组合仪表电机检测-The stepper motor zero-bit detection, NEC DX2 program for the detection of combination meter motor
PPDataRTPro
- 8051单片机点对点之间的通讯程序，数据发送与接收-8051 point-to-point communication between the program, data transmission and reception