资源列表
TouchScreen
- DQ-STM32开发板试验程序 触摸屏实例 加载程序后点击屏上不同的色块更换画笔的颜色 按CLR部分清屏 端口分配详见原理图 重庆DQ电子 -DQ-the STM32 development board test program the touchscreen instance loader click on the different blocks of color on the screen to replace th
USART1
- DQ-MVX-S2开发板试验程序 UART中断收发实验 通过UART1接收数据，当数据填满接收缓冲器时，将接收的数据发送到PC 波特率为115200 端口分配详见原理图 (USB转串口方式)-DQ-MVX-S2 development board test procedures UART interrupt the transceiver experiment UART1 receive data when the data
I2Ca
- It runs a real time clock with atmega8. After writing time at first it start.
CAR
- 遥控车，壁障，基于at89s52的c语言源程序-C source of Remote car condition , based on the at89s52 SCM
smartcar
- 第七届飞思卡尔智能车比赛的初步程序，较好实现自平衡-Preliminary program of the Seventh Freescale Smart Car Competition, better self-balancing
LY5A-L12
- 急弯道路来车提示系统设计全部源代码，自己设计的 ，写得不咋滴，欢迎指点-Sharp bends of the road to the car prompts system design with full source code, written not gnaw, welcome advice
hello
- lm3s驱动tft液晶屏，tft控制器是S6D01-lm3s drive tft LCD screen of tft controller is S6D0144
uart_echo
- lm3s9b96的uart测试程序，可用于串口调试-lm3s9b96 UART test program can be used for serial debugging
led
- lm3s9b96的led交替闪烁例程，LM3S入门例子-lm3s9b96 led alternately flashing routines, LM3S example
xmodemCRC16.c
- 本人根据XMODEM协议的16位CRC校验方式CRC--CCITT(X^16 + X^12 + X^5 + 1)，根据其理论思路一步一步编写的源代码，按照程序思路，会比较容易理解CRC16较验方式的来龙去脉。 -I according to the XMODEM protocol 16 of the CRC method CRC- CCITT (X ^ 16+ X ^ 12+ X ^ 5+ 1), according to their theoretical ideas step by st
24064-0k
- 一个液晶显示模块240*64分辨率的源代码C文件，驱动IC为T6963C 。-An LCD module 240* 64 resolution of the source code for C files, the driver IC of T6963C.
lm3s-rtc
- ARM LM3S MCU由自身管脚产生32786.885Hz方波，为RTC功能提供时钟源，计算并将RTC时钟数值通过串口发送给PC显示。-ARM LM3S the MCU to produce a square wave 32786.885Hz own pin for RTC function clock source, calculation and RTC clock value sent through the serial port to the PC display.