资源列表
Serial_display12864
- 51单片机的12864串行传输程序，12864的后方电阻可能要改动-51 SCM 12864 serial transmission program, 12864 of the rear resistance may want to change
ds18b20
- 51单片机的ds18b20完整程序，数码管显示-51 SCM ds18b20 complete program, digital pipe display
1602
- msp430f149的1602液晶驱动程序-it s a driver text for 1602
ARM-program-14
- ARM C program ZigBee 无线网络 应用 带电路图-ARM C program ZigBee wireless network application take diagram
ARM-program-13
- ARM C program WiFi 无线网络应用-ARM C program WiFi wireless network applications
ARM-program-11
- ARM program C IrDA红外通信应用-IrDA infrared communications applications of the ARM program C
ARM-program-3
- ARM 步进电机驱动 C程序 带电路图-ARM microcontroller stepping motor driver have circuit C program
hz
- 本程序用AT89S51单片机的T0、T1的定时计数器功能，来完成对输入的信号进行频率计数，计数的频率结果通过8位动态数码管显示出来。可对0－250KHZ的信号频率进行准确计数，计数误差不超过±1HZ。-AT89S51 microcontroller T0, T1 timing counter function of this program, to complete the input signal frequency count, count the frequency of the resu
0.01miaobiao
- 本程序是六位数码管0.01秒表显示程序，用STC89C52制作，晶振为11.0592MHZ,供大家学习之用！-This program is six digital tube 0.01 stopwatch display program, produced by STC89C52, crystal 11.0592MHZ, for learning!
SHIDONG
- 本程序是六位数码管时钟显示程序，用STC89C52制作，晶振为11.0592MHZ,供大家学习之用！-This program is six nixie tube clock display program, produced by STC89C52, crystal 11.0592MHZ, for learning!
DAC0832
- DAC0832详尽资料，引脚功能，时序图，DDS低频信号发生器，三角波，正玄波，梯形波-failed to translate
1602
- 本程序是1602液晶时钟显示程序，用STC89C52制作，晶振为11.0592MHZ,供大家学习之用！-This program is the 1602 LCD clock display program, produced by STC89C52, crystal 11.0592MHZ, for learning!