资源列表
ks108
- 此代码是在keil环境下做stc89c51单片机的开发，主要围绕c51单片机实现ks108液晶模块的显示功能。-This code is in the the keil environments do stc89c51 microcontroller development, mainly around the c51 microcontroller ks108 liquid crystal display module.
ch8_1
- 基于pic单片机的8段数码管的显示 适合初学者的练习-Based on the pic microcontroller digital tube display Exercises for beginners
ch7_4
- pic单片机的中断控制 可以根据信号灯的闪烁看是否进入中段-pic microcontroller interrupt control Can see lights flashing whether to enter the middle
ch7_1
- 基于pic单片机的延时控制显示灯的程序。 时间是根据定时器控制的。-Pic microcontroller-based delay control display lights program. The time is under timer control.
ch2_1
- 基于pci单片机的LED灯的闪烁程序 新手学习专用。-Pci single chip LED lights flashing program Novice learning dedicated.
222
- 单片机实现控制水箱系统的程序源代码，可以使用-The C language image reading and display program source code, can be used
USB-on-the-goy
- 非常有用的STM32F103单片机详细资料，很适合初学者使用-The details of very useful STM32F103 microcontroller, it is suitable for beginners
51
- 设计并制作一台出租车计价器。调试时采用10Hz方波信号模拟，每个方波代表10m-Design and making a smart meter taxi. The 10 Hz debugging square wave simulation signal, each square wave represents 10 m
timer-
- C语言写的可用单片机控制的红绿灯模拟系统-the mimic of timer of red and yellow and green system
gsm-dialer-1.3
- GSM 拨号器，可自动拨号，支持CID,4+2，来电显示，DTMF解码，各种信号音控制，有线和GSM自动切换-auto dial，CID and 4+2 mode，ring display，DTMF decode，signal control，and switch each other from GSM and PSTN.
uart
- ARM的P0.0口接LED，串口接Proteus的虚拟终端。每隔一段时间改变一次LED的状态，并且在串口上输出LED的当前状态。-LED contact the port P0.0,and uart port contact the Proteus virture terminal . alter the LED state every a time,and output the curent state to the termial.
USBasp
- 单片机嵌入式开发过程中需要用到的USB下载器的驱动程序，windows下运行-USB download device drivers, embedded microcontroller development process need to run under Windows