资源列表
Gpio-tube-feet-programming
- stm32的c语言编程，实现对I/O管脚的相关控制-The stm32 c programming language, and to realize the I/O tube feet of relevant contro
zhinengxiaoche
- 基于单片机的智能灭火小车的小车的系统设计-Based on single chip microcomputer intelligent fire extinguishing system design of the car of the car
DS18B20-temperature-detection
- DS18B20程序，基于STM32的板子，本人亲测，在板子上完美运行-DS18B20 program running smoothly, I pro-test, run perfectly on the board! ! ! !
8255keyboard
- 8255 键盘 led显示 8255 keyboard led display-8255 keyboard led display
flash
- 用于MSP430F149。 FLASH存储器读、写、段擦除 从程序存储器的两个数组内分别读出N_DATA个字节和字，写入信息存储器和FLASH中某 一段内，然后再将写入的内容读出到RAM中的数组中进行验证。 -For the MSP430F149. FLASH memory read, write, erase segments From within the program memory of the two arrays
pwm
- 使用定时器B进行PWM输出。输出的频率和占空比由串行口发送来的指令确定。-Use the timer B for PWM output. Output frequency and duty cycle from the serial port to send commands to determine.
timer
- 用于MSP430F149。 定时器B产生大约1ms的定时，使主程序退出低功耗模式。主程序执行一遍流程，再 次进入休眠，等待下一次被唤醒。-Timer B to generate approximately 1ms of the time, so the main program to exit low-power mode. Again the main program execution flow, and then Time to sleep, waiti
6-2
- UART异步串行多点通讯从机程序。使用USART0。 晶体振荡器 XT2：8MHz LFXT1：32.768kHz 波特率:9600bit/s，8位数据位，1位停止位，地址位多机协议-Multi UART asynchronous serial communication program from the machine. Use USART0. Crystal oscillator XT2: 8MHz LFXT1: 32.768kHz Baud
usart1
- msp430，异步通信模块程序，usart，测试通过-msp430, asynchronous communication module program, usart, test
Single-temperature-sensor18b20
- 单总线温度传感器，51单片机，keil实现 单总线温度传感器，51单片机，keil实现-Single bus temperature sensor, microcontroller 51, keil achieve
Traffic-light
- 红绿灯，51单片机，keil实现 红绿灯，51单片机，keil实现-Traffic light, 51 microcontroller, keil achieve
48-AD_DA_PCF8591
- adda，51单片机。keil实现 a dda，51单片机。keil实现-adda, 51 microcontroller. keil achieve