资源列表
ads
- 采集ADS7841驱动代码,根据英文芯片资料时序图得来(sample the ads7841 chip code)
LED
- 点亮led 不使用其他平台说给的定义引脚方法(Lighting LED does not use other platforms to define the pin method)
HC-SR04_2in1_1610181019
- 利用定时器的捕获功能测量脉宽，可以应用于超声波测距。(utilize timer capture funtion to measure pulse width, which can apply to ultrasonic ranging.)
AD9959-DDS-new
- AD9959-DDS-new 原理图，高频信号(AD9959-DDS-newThe AD9959 consists of four direct digital synthesizer (DDS) cores that provide independent frequency, phase, and amplitude control on each channel. This flexibility can be used to correct imbalances between si
新建文件夹 (2)
- #define uint unsigned int #define uchar unsigned char sbit dula=P0^1; sbit wela=P0^3; uchar num; uchar code table[]={ 0xc0,0xf9,0xa4,0xb0, 0x99,0x92,0x82,0xf8, 0x80,0x90,0x88,0x83, 0xc6,0xa1,0x86,0x8e}; void delay(uint z); void main() {
OV7725
- 摄像头7725驱动，配合STM32F4，速度快效果好(ov7725 driver and STM32F4)
Tiny4412C语言实现流水灯
- 在TINY4412开发板上，跑的裸机流水灯程序，初学者可以看看(In the TINY4412 development board, run the bare light water program)
STM32_UCOS-II
- STM32移植好的UCOS-II，创建了3个任务，每个任务都是点一个LED灯，运行正常； 拿来可以直接用，KEIL4下编译；UCOS-II2.86版本(STM32 transplantation of good UCOS-II, created 3 tasks, each task is to point to a LED light, running normally; can be used directly, KEIL4 compiled; UCOS-II2.86 version)
mpu6050
- 利用单片机读取mpu6050的数据。用加速度值输出的数据求出X和Y轴上的倾斜角；用陀螺仪输出的的角速度值积分出旋转角度。 然后融合加速度计与陀螺仪的数据，最后滤波获得更好的效果。(Use singlechip to read mpu6050 data. The angle of the X and Y axes is calculated by the output data of the acceleration value, and the rotation angle is integra
STM32-AD
- STM32双通道AD数据采集，DMA接收，USART发送(STM32 double channel temperature data acquisition)
2.51单片机CS5460A程序
- 通过cs5460计量芯片完成对电压、电流、有功功率、无功功率、功率因数的采集(Through the CS5460 measuring chip, the voltage, current, active power, reactive power and power factor are collected)
temperature recorder
- 在keil编程环境下用模块化编程实现温度的定时记录功能。(In the Keil programming environment, with modular programming to achieve temperature timing recording function.)