资源列表
keil
- 外部中断实验!!! 1）p0口接8个发光二极管，共阴极接法，要求：如果外部中断0维持接低电平，则8个二极管保持全灭状态，一旦外部中断0接高电平，则8个二极管恢复保持全亮状态； -External interrupt experiment!!! 1) P0 with 8 light-emitting diodes, commoncathode, requirements: if the external interrupt 0 maintain the low level, th
keil
- 4）P0口接2个八段式共阴极LED数码管，片选信号分别接P1.0，P1.1，让两个数码管动态显示01直至10共计10个数码，再重新循环，数字持续时间自定；- 4) P0 port 2 eight segment common cathode LED digital tube, chip signal are respectively connected with the P1.0, P1.1, two dynamic digital display 01 to 10 a total of
keil
- 3）P0口接2个八段式共阴极LED数码管，片选信号分别接P1.0，P1.1，让两个数码管显示数字57；-3) P0 port 2 eight segment common cathode LED digital tube, chip signal are respectively connected with the P1.0, P1.1, two digital tube display digital 57
keil
- 单片机点亮数码管实验（不能用定时器功能） P0口接1个八段式共阴极LED数码管，通过调用延时子程序，循环显示0-9，时间间隔自定，注意使用一维数组给出显示代码-MCU lit digital tube experiment (can not use the timer function) P0 port connected to the 1 paragraph of the common cathode LED digital tube, by calling the delay sub
keil
- 一、单片机点亮8个发光二极管实验 1）P1口外接8个共阴极发光二极管，点亮高4位； 2）p0口接8个共阳极发光二极管，点亮高4位； 3）P0口接8个共阴极发光二极管，点亮高4位；-A single chip lit 8 light-emitting diode experiment 1 (P1) 8 common cathode light-emitting diodes, light up to a high of 4 2) P0 port to con
RC522-by-lcd
- STM32+读卡器模块rc522+RFID读取 +lcd显示例程-STM32+ card reader module rc522+ RFID read+ lcd display routine
atmeag8-battery-capacity-test
- 基于ATM eag8设计的电池容量测试仪,软件为C语言,硬件为AD格式.-Based on the ATM eag8 design of the battery capacity tester, the software for the C language, the hardware for the AD format.
Ultrasonic--ranging
- 超好的超声波测距程序，，能实现测距，我这个程序花了一周才写出来，分享给大家-Ultra high precisionultrasonic ranging program
spi_lcd5110-
- STM32的NOKIA 5110液晶程序，带了DMA哦，强烈推荐，我改了多次，2017年最新上传，PUDN独一无二。-STM32 NOKIA5110
YEJINGPING
- 有关c51单片机的keli和proteus的液晶屏的c语言编写和仿真模型的搭建- U6709 u5173 u5355 u7247 u7287 u7684 u7684 u642D u5AR
PWM
- 脉宽调制PWM在小车中的应用，包含介绍文档，和相应代码。-Pulse width modulation PWM in the car in the application, including the introduction of documents, and the corresponding code.
L298N_drive-module
- L298N电机驱动模块，包含L298N的详细资料和操作程序。-L298N motor drive module, including L298N details and operating procedures.