资源列表
SG90
- 程序是基于STM32F103ZET6实现舵机调试，源码可以实现用户给指定角度，然后舵机转到相应角度-Procedure is based servo STM32F103ZET6 achieve debugging, source code may be implemented for the user to specify the angle, and steering angle corresponding to
ultrasonic
- 本程序是在STM32F103ZET6单片机的定时器输入捕获功能实现超声波模块的调试-This program is an input capture function in timer STM32F103ZET6 single-chip debug module to achieve ultrasonic
RC_A7159_x0_470-510MHz-Band-Ref
- 获得IPC的信息，可以根据IP地址决定是否增加设备-Based on the official A7159 wireless transmission code routines
MB91F59x_CAN_Bootloader_V1.1_53B_DM
- 富士通单片机底层驱动，关于MB91530的启动代码，可以作为参考，来写自己的bootloader.-Fujitsu microcontroller bottom drive, MB91530 on the boot code, can be used as a reference to write their own bootloader.
volume
- STC15W204S单片机的音量，控制器左右声道独立控制，杰理AC1082状态控制，内置3种正弦波音频信号，用于音响类开发-STC15W204S, the volume of the single chip microcomputer controller around a track control independently, jie AC1082 state control, built-in 3 kinds of sine wave audio signal, is used to so
MC9S128XEP_485
- MC9S128XEP 485 已经在硬件上调试通过，需要移植的放心使用-MC9S128XEP 485
SCI_Receve_send_receve
- MC9S128XEP SCI_Receve_send_receve 已经在硬件上调试通过，需要移植的放心使用-MC9S128XEP SCI_Receve_send_receve
mc9s128XEP_CAN_SendAndReceve
- MC9S12XS128 CAN通讯发送接收源代码，已经在硬件上调试通过，需要移植的请放心使用-MC9S12XS128 CAN SEND AND RECEVE
ADC-TCP
- MCU内置ADC采集电压数据，通过wifi模块的TCP传输给服务端，模块作为客户端-send adc data to server with wifi
GPS-display
- GPS分路显示终端源代码，通过串口读取GPS数据并在液晶显示屏显示经纬度数据。-GPS shunt display terminal source, read through the serial GPS data and the longitude and latitude data displayed on the LCD screen.
Bcode-inaout
- B码终端单片机源代码，配合B码终端使用，可以解调显示B码时间，也可以编码输出B码-Microcontroller source code of the terminal B, with the B terminal code used for encoding or decoding code B
Bcode-convert
- B码转换，读取B码编码，提取数据，从串口输出-B code conversion, read B code encoding, extracting data the serial output