资源列表
C
- 以红外线传感器ST188或ST178作为小车的测距传感器，进行障碍物探测。当发现障碍时，给出报警信号自动适应当改变行进方向继续前行。-Infrared sensor ST188 or ST178 car distance measuring sensor, obstacle detection. When the obstacle is found, an alarm signal is given automatically adapt when changes of direction to
openpcd_v04_gerber
- 基于pn532的NFC开放源电路图设计电路板openpcd 原理图及pcd图-A PN532 NFC open schematic design board-based openpcd Schematics and PCD map
atod_conversion
- It contains a source code to use the inbuilt ADC module present in the PIC18F4520
clock
- 在实验箱上设计并实现一个带闹钟的日历钟，要求至少用到端口功能、按键中断功能、外部中断功能、LCD功能、8位定时器/事件计数器5的定时功能、实时计数器的日历和时钟功能。-Experimental tank design and a calendar with alarm clock, requires at least use the port function key interrupt function, the external interrupt function, LCD functi
Simulink
- simulink基础教程，非常详细容易上手-simulink based tutorial, very detailed and easy to use
The-NEC-78K0-KC2-8-bit-
- NEC 78K0—KC2 8位单片机 24Cxx adc.c flash-spi.h pca955x.clcd.c iic0.c-The NEC 78K0-KC2 8-bit microcontroller 24Cxx adc.c flash-spi.h pca955x.clcd.c iic0.c
SendSMS
- arduino单片机GPRS模块发短信，实现远距离通信功能-the Arduino microcontroller GPRS module texting, long-distance communication function
s51yk
- 51单片机遥控上位机程序（51），可以配合上位机软件实现红外遥控-51 single-chip remote host computer program (51), infrared remote control with the PC software
STK500-Clone
- STK500 Clone via serial port, Support ATMEL Studio 6
main
- 实现lin通信，能够实时的把数据传给上位机，希望对你们有用-Lin bus communication function, can pass data to PC, real-time hope helpful for you
STM8A_CLK
- 在MCU启动后，负责时钟模块初始化， 并从默认的内部时钟切换到外部时钟。 提供关断MCU 外围模块时钟的接口函数-After the MCU startup, is responsible for the clock module initialization, and switch from the default internal clock to the external clock. Provides shutoff MCU peripheral interface function m
BCM1_Timer
- 定时器4提供10ms的定时功能，作为系统节拍。 定时器1的1~4通道，定时器3的2通道，提供5个通道的PWM输出。 定时器3的1通道用作内部输入捕捉，校准最小时钟源。 定时器2为LIN提供时钟源（本模块不作处理）。-4 provide 10 ms timer timing function, as a system. Timer timer 1 of 1 ~ 4 channel, 3 2 channel, provides five channels PWM output.