资源列表
12AD
- 这是串行AD采集芯片ADS7816的读写程序，采用Keil编译其输出数据的格式是最高有效位(B11位)在前,当最低有效 位(B0位)输出后,若CS变为高电位,则一次转换结束,最高转换速度200kHz-。-This is the serial AD acquisition of reading and writing chip ADS7816 procedure for the Keil compilerthe output data format is the most significant
SPIADS7816
- SPI接口的ADS7816，其输出数据的格式是最高有效位(B11位)在前,当最低有效 位(B0位)输出后,若CS变为高电位,则一次转换结束,最高转换速度200kHz-。-This is the serial AD acquisition of reading and writing chip ADS7816 procedure for the Keil compilerthe output data format is the most significant bit (B11-bit) in
AVRSPI25C256EEPROM
- 基于AVR单片机的SPI接口的25C256（EEPROM）的驱动程序-AVRSPI24C256(EEPROM)
sim300_atc_v2.03
- Sim300 Lib document ,you can get refrance from it
mp3ruanjianjiema
- mp3的软件解码C语言编写 嵌入式开发中会用的到的-mp3 decoding software development in embedded C language will be used to the
paduijiaohao
- 嵌入式排队叫号系统其余44b0的开发，压缩文件中包含了程序代码和论文-The rest of the embedded queuing 44b0 calling system development, compressed file contains the program code and papers
ARMpdf
- 关于ARM的开发详解的介绍包含了 ARM处理器的介绍，嵌入式linux的开始介绍，ADS的使用介绍-Developing Detail Explain on the ARM' s introductory presentation included ARM processor, embedded linux to begin with, ADS introduced the use of
LED
- LPC2106的裸机程序控制LED数码管显示0-F字符,同时控制4个LED显示对应的十六进制。-LPC2106 bare metal process control LED digital display 0-F characters, simultaneous control of four LED display the corresponding hexadecimal.
ADC
- LPC2106的裸机程序，控制ADC模块转换。-LPC2106 bare metal process, the control module ADC conversion.
FIQ
- LPC2106的裸机程序，控制FIQ中断。-LPC2106 bare metal process control FIQ interrupt.
i2c
- LPC2106的I2C程序，控制I2C模块工作。-LPC2106 I2C-process control I2C module.
PWM
- LPC2106的PWM控制程序，一个采用PWM控制蜂鸣器0.5S响一次，一个为PWM的双边沿控制程序。-LPC2106 the PWM control procedures, a PWM control with a buzzer 0.5S ring, one for the double edge PWM control procedures.