资源列表
16x16LED
- 16X16点阵屏，包含源码和仿真，4个595级联驱动-16X16 dot matrix screen, including source code and simulation, 4 595 Cascade Drive
DA2
- DA转换，将数字量转换成模拟量，以供其他器件选择-DA conversion, the digital into analog volume for the other device selection
DA3
- DA转换，TLC5615模拟 SPI通信，将数字量转换成模拟量-DA converter, TLC5615 simulation SPI communication, the amount will be converted into analog digital
lcd12864
- 12864 液晶屏显示代码，实现两种控制方式，串行引脚控制，并行IO控制，AVR源代码-12864 LCD display code to achieve two control modes, the serial pin control, parallel IO control, AVR source code
car_read
- 汽车发动机转速检测 保护控制器，C51单片机，测试发动机每秒转速，设置保存在I2C芯片，1602液晶显示菜单。-Car engine speed detection protection controller, C51 microcontroller, test engine per second speed settings are saved in I2C chip, 1602 LCD menu.
ir---24Mhz
- NEC遥控器解码控制，贴片LED显示时钟，6片595级联显示，STC12C5616AD单片机，实现闹钟，温度DS18B20，时钟，LED PWM RGB调光，背景呼吸灯调光。-NEC remote control decoder control, SMD LED display clock, 6 595 cascade show, STC12C5616AD microcontroller, to achieve alarm clock, temperature DS18B20, clock, L
JetBeam
- JetBeam infrared (IrDA) protocol stack 1-JetBeam infrared (IrDA) protocol stack 1999
pic10f222
- 单片机做的门铃程序，已调试通过，可正常使用-The program to do, has been debugged, can use normally
HYG1926445C-FF62L-VB
- 此为华远显示128*64 LCD驱动程序，该程序也适用于带NT7108C控制器的LCD-This is the Huayuan 128* 64 LCD display driver, the program also applies to LCD controller with NT7108C
code-for-interfacing-24C04-I2C-EEPROM-with-8051.r
- EPROM INTERFACE WITH 8051
signal-generator-v1.0
- 基于C8051F020单片机的信号发生器设计，实现的功能输出波形：正弦波，方波，三角波，频率100Hz~10KHz（未使用DDS设计）-Based on C8051F020 MCU signal generator design, functions output waveforms: sine, square, triangle wave, frequency 100Hz ~ 10KHz (unused DDS design)
CSR_BT_atenna_design_guide
- CSR蓝牙芯片的天线设计指导文档，主要为PIF天线和蛇形PCB天线。-CSR Bluetooth chip antenna design guidance documents, mainly for PIF antenna and serpentine PCB antenna.