资源列表
STM32F103-uCGUI
- STM32F103ZET6上成功移植的uCGUI，完整工程。液晶使用ILI9341驱动。KEIL开发环境，打开就可以运行。方便uCGUI的学习-On STM32F103ZET6 successful transplant uCGUI, complete works. Use ILI9341 LCD driver. KEIL development environment, open to run. Facilitate learning uCGUI
68013
- 68013芯片的驱动程序，固件程序，以及上位机程序源代码-68013 chip drivers, firmware, and PC program source code
bujindianjikongzhichengxu
- 该程序用于步进电机的正反转驱动以及正反转加减速，并且用于51单片机编程-The program is used to drive the stepper motor rotating and reversing acceleration and deceleration, and for 51 single programming
Multimeter-verification
- 基于UCOS UCGUI的万用表校验仪系统的实现。是一个成品的源码。对学习UCOS UCGUI很有帮助 处理器用的是STM32-Achieve UCOS UCGUI multimeter calibrator system. Is a finished product source. UCOS UCGUI helpful in learning to use the STM32 processor
TIMER--RTC
- STM32的RTC实时时钟的实现并通过OLED显示-Achieve the STM32 RTC real time clock and through OLED display
one_1Q
- This verilog code for 2*1 mux.-This is verilog code for 2*1 mux.
one_2Q
- This Verilog code of 4*1 mux using 2*1 mux.-This is Verilog code of 4*1 mux using 2*1 mux.
communication-for-maxon-motion
- 一个简单的小例程，用于实现maxon第三方电机与beckhoff控制软件之间的通讯-A simple little routines for the third-party communications maxon motor control software with beckhoff between
SD SPI
- this is the code SPI SD card
PIT-
- 根据freescale的16位单片机HCS12（XS128）系列的PIT中断源程序-16-bit microcontroller based on freescale HCS12 (XS128) series PIT interrupt source
MorseTranslation
- Arduino(cpp), morse code on arduino platform.
MCU5
- 单片机 配置 实验