资源列表
ZigbeeBEGIN
- 基于zigbee的组网调试程序，是初学者可以学习的基础实验，有相应说明文档和程序。-Zigbee networking based debugger, beginners can learn the basic experiment, there is a corresponding documentation and procedures.
hal_lcd
- LC12864的驱动文件，适用于CC2530，经过调试验证。-Drivers LC12864, applied to CC2530, after debugging verification.
xiandaitongxin
- 基于matlab的现代通信原理实验，包含具体的实验报告和实验源程序，以及实验结果。用matlab7.1版本即可实现。-The modern communication principle experiment based on MATLAB, including experimental report specific and test source code, as well as the experimental results. Using Matlab7.1 version.
TCON_HX8257.c.tar
- HX8257 series interface TCON source
dianyabiaocesih
- 5v电压表 已经测试成功，用的是ADC0809 程序很简单-5v vlotmeter
buzzer
- 基于mini2440开发板的蜂鸣器裸机程序，已经在ADS1.2上调试过。-Buzzer mini2440 development board based on bare metal procedures have been tried to increase the ADS1.2.
mini2440-key
- 基于mini2440开发板下的按键裸机程序，用扫描法，已经在ADS1.2上运行过了。-Mini2440 development board based on bare metal keys under the program, with the scanning method, already on ADS1.2 run over.
mini2440-uart
- 基于mini2440开发板下的串口读写字母程序，已经在ADS1.2上运行过了。-Mini2440 development board based on serial read and write the letters under the program has been run over in the ADS1.2.
my3.5
- 嵌入式开发，在STM32平台上利用c++语言编写的工程模板-Embedded development on STM32 platform using c++ language project templates
lcd
- PSOC修复LCD左边四位不能写文字的问题。-LCD_ROW1_OFFSET: equ 80h Address/command offset for row 1 LCD_ROW2_OFFSET: equ C0h Address/command offset for row 2 LCD_ROW3_OFFSET: equ 8Fh Address/command offset for row 1 94h--8Fh LCD_R
Timer-key-debounce
- 通过定时器定时来给按键消抖，每隔一段时间进行一次定时中断。-Timer key debounce
M128-Direct-Drive-24064
- Atmega128 drive controllerless LCD 240*64