资源列表
USB
- STM32嵌入式系统的USB读卡器应用试验程序，-USB card reader embedded systems application test program
stm8s_pt2262Decode_uart
- stm8s 的pt2262解码+发射 uart版-stm8s pt2262 Decod+ uart
AT45DB161D(2014.07.15)
- AT45DB汉字库,MDK工程，16x16字体-AT45DB character base, MDK engineering, 16x16 font
DDSPDQPSKmatlab-SIMULATOR
- 对原始信息先进行扩频然后进行DQPSK调制的MATLAB程序，参考了一些扩频仿真程序后自己完善的，目前网站上没有一个完成的扩频通信的仿真程序（扩频与调制完全结合在一起的）-PN CODE,DDS,DQPSK
XIANHAOFASHENG
- 51单片机C语言编制的简易信号发生器，分别产生100hz,75hz,50hz,25hz,10hz,1hz信号，时间间隔为5秒。-Simple signal generator 51 microcontroller C language, and generate 100hz, 75hz, 50hz, 25hz, 10hz, 1hz signal interval is 5 seconds
Glcd-devices
- Glcd驱动，验证成功才上传的，使用时根据引脚稍稍修改一下，如不想修改按程序内定义的连接即可。stm32f103vbt6-Glcd drive, the validation is successful only upload when used in accordance with the pin slightly modify it, such as do not want to modify the connection can be defined according to intern
usb-SOUND
- stm32f103vbt6 声卡驱动，经过验证声音很好，，验证成功才上传的，使用时根据引脚稍稍修改一下，如不想修改按程序内定义的连接即可。-Sound card drivers, sound good,, proven successful verification only uploaded when using the pin slightly modified according to it, such as do not want to modify the connection wit
stm-led
- stm32标准模板，控制led灯，可读写时钟模块验证成功才上传的，使用时根据引脚稍稍修改一下，如不想修改按程序内定义的连接即可。(声明：本人上传所有程序均是测试过的好用的.用户名zhaoxuan1190)-stm32 standard templates, control led lights, can read and write clock module validation is successful only upload when used in accordance with the
ch12
- nor闪存。验证成功才上传的，现在还在正常使用。-nor flash. Verification was successful upload, is still normal use.
Light-cube
- 光立方的资料，包括电路图，源代码，上位机软件-Light cube data, including circuit diagrams, source code, PC software and so on
SD-CARD
- 该程序实现在MINISTM32板子上对SD内存卡里面内容的读取，测试效果不错。-The program implemented on board MINISTM32 read the contents of the SD memory card inside, the test results are good.
TI-LDC1000STM32-0.1
- 2014ti杯电子设计大赛LDC1000驱动程序-2014ti Cup Electronic Design Contest LDC1000 driver