资源列表
petitfs_test
- petit fs test on stm32f103 blue pill
USART_DMA
- 使用STM32CubeMX配置生成Keil4工程，实现串口接收不定长字符串(STM32CubeMX configuration is used to generate Keil4 engineering to receive indefinite long string by serial port)
借鉴2
- GT21L16S2Y的驱动程序，引用于lcd的显示汉字的功能上(The GT21L16S2Y driver, which refers to the function of LCD's display of Chinese characters)
RTClib-master
- It is used for including rtc to any arduino circuit
LED BLINKING
- make a blinking leds with atmega32
lesson6 SysTick-系统定时器
- SysTick 寄存器配置 SysTick 配置项 SysTick 中断配置流程 SysTick 中断处理流程(SysTick register configuration SysTick configuration item SysTick interrupt configuration process SysTick interrupt processing flow)
ads1158配置
- 首先说明ADS1158命令读写模式，然后解析命令含义及配置顺序等。(First, the ADS1158 command read and write mode, and then parse the command meaning and configuration order and so on.)
222
- d f g r klk;lk;l oi iiiiee e eeeeeeeeeee o o o eeeeeee
LEDreg
- led driver controller untested
16F877X Bootloader
- Microchip PIC16F87x Bootloader/Downloader
PL2303驱动
- pl2302驱动1.用USB线连接学习板和电脑。随后会听到叮咚一声。并弹出一个对话框。 2.关闭该对话框。运行光盘中PL2303文件夹下 HL2303。按提示进行操作即可 3.安装成功后会在设备管理器 COM口选项中看到连接的COM口是多少 4.打开STC_ISP软件 选择芯片型号，COM口 5.切记 点击下载后冷启动下学习板。即关闭电源，在重新打开下(1. use the USB line to connect the learning board and the computer.
JLINK V8 固件恢复办法
- 是单片机工程师必备软件，JLINK固件恢复方法(The JLINK firmware recovery method is the necessary software for the single chip computer engineer)