资源列表
Test_BatterySensor
- 基于JN5139这款SOC芯片的数据采集程序，利用GAINSJ开发套件上的温湿度传感器，将测得的温度，湿度值通过PC机的串口调试助手最终显示到PC机上。开发环境为Jennic CodeBlocks软件，使用C语言编写。-This SOC based on JN5139 chip data acquisition program, using GAINSJ development kit on the temperature and humidity sensors, the measured t
BaseIEEE802.15.4
- 利用JN5139实现2个节点之间基于IEEE802.15.4标准的通信。网络拓扑结构为星型，节点一个为Coordinator节点，一个为Enddevice节点。开发环境为Jennic CodeBlocks软件，用C语言编写。-Used to achieve two nodes JN5139 IEEE802.15.4 standards-based communication. For the star network topology, node 1 as the Coordinator nod
Test_ADC
- JN5139芯片自带的ADC接口（12bit），最快采样频率27.8K，该程序将GAINSJ开发套件上的模拟电压（电池电压）通过ADC转换成数字信号，并通过串口传到PC机上显示出来。开发环境为Jennic CodeBlocks软件，采用C语言编写。-JN5139 chip onboard ADC Interface (12bit), the fastest sampling frequency of 27.8K, the program will GAINSJ Development Kit o
test
- 凌阳61板模拟红绿灯程序，适合新手熟悉I/O口的使用-Sunplus 61 board simulated traffic light program, suitable for novice familiar with the I/O port to use
honglvdeng
- 凌阳61板模拟红绿灯，适合新手熟悉I/O口的使用。-Sunplus 61 plate simulated traffic light, suitable for novice familiar with the I/O port to use.
KS0108_drive
- KS0108驱动LCD液晶显示程序,挺有用的-KS0108 Driver LCD liquid crystal display program, winter ridge used
MSP430_C_softcode_hard_dsigner
- MSP430初学者的向导，包含C源代码实例，硬件电路图设计实例！是入门的好资料！-MSP430 beginner' s guide, including C source code examples, hardware schematics design example! Is a good entry information!
FIR532
- BF533的开发板实现低通高通带通带阻的滤波器FIR的滤波器 很好用哦-BF533 development board low pass high pass filter band-pass FIR band-stop filter with the Oh well
eeprom-USART_OUT
- 用STM32F103RB模拟IIC（PB6，PB7）读EEPROM输出到串口一。-Simulation with STM32F103RB IIC (PB6, PB7) output to serial EEPROM read one.
1702sl_source_code
- 1702sl源码和示例程序，整个keil工程-1702sl source and sample programs, the keil project
Denys1
- ADC measuring magnetic field
test
- 采用A7105芯片的电子防丢器，在主从模块超过设定距离时自动报警。-A7105 chip with electronic anti-lost alarm, in the main module exceeds a set distance from the alarm.