资源列表
anjian
- 一键多功能识别，有完整思想由来和设计原理图。包换C和汇编程序！-A key function identification, origin and design a complete schematic thinking. OZ C and assembler!
dianya
- 数字电压表，电路图，设计思想，C，汇编，应有尽有。自己看吧！-Digital voltmeter, circuit design, C, assembly, everything. It yourself!
suo
- 根据设定好的密码，采用二个按键实现密码的输入功能，当密码输入正确之后，锁就打开，如果输入的三次的密码不正确，就锁定按键3秒钟，同时发现报警声，直到没有按键按下3种后，才打开按键锁定功能；否则在3秒钟内仍有按键按下，就重新锁定按键3秒时间并报警。-According to set good password, the password used to achieve two key input, when the password is correct, the lock will open, i
wendu
- 用一片DS1624完成本地数字温度的测量，并通过8位数码管显示出测量的温度值。-DS1624 completed with a local digital temperature measurement, and by 8-bit digital display the measured temperature.
lamu
- 用AT89S51单片机的P0.0/AD0－P0.7/AD7端口接数码管的a－h端，8位数码管的S1－S8通过74LS138译码器的Y0－Y7来控制选通每个数码管的位选端。AT89S51单片机的P1.0－P1.2控制74LS138的A，B，C端子。在8位数码管上从右向左循环显示“12345678”。能够比较平滑地看到拉幕的效果。-P0.0/AD0-P0.7/AD7 with AT89S51 microcontroller port connected digital tube a-h-side,
TC35I-test-board-circuit-schematics
- TC35I实验板电路原理图：详细介绍了西门子TC35I模块与单片机的连接，与NAX232的连接，以及LM2941电源电路和其它外部控制电路-TC35I test board circuit diagram: Siemens TC35I described in detail the connection module and the microcontroller, and NAX232 connection, and the LM2941 power supply circuit and ot
dianzhen
- 点阵0~9显示数字，其中包含原理图，详细讲解。汇编和C程序！-Dot matrix display numbers from 0 to 9, which contains schematic, explain in detail. Assembly and C program!
line_trc_3_sen_3
- AVR LINE TRCING FILE FOR THE LINE TRACING ROBOTS USED AVR MICROCONTROLLER
source
- Line tracer Source code AVR128
PID_Simulator_V1.0
- This is a simple PID simulator, it is very easy to learn PID algorithm.
robot_control
- 通过单片机C8051F040软件输出多路PWM波，用于双足竞步机器人控制，获得较好的控制效果-C8051F040 MCU software through multiple PWM wave output for Biped Robot Walk Control, to obtain better control effect
LabView
- 阿尔泰PCI8664的采集卡labview程序-PCI8664，labview，programm