资源列表
BG0328
- sensor BG3028的初始化设置，已经可以正常出图象-sensor BG3028 init
fifty-hz-pulse
- //This Code is for PIC18f4520 Controller, //it is Simply a test for generating 50Hz frequency on Port C //of Microcontroller, Program is written in MPLAB of Microchip.
Pic-Microcontrollers-book
- PIC Microcontrollers book by Bates
Msp430f6638
- 它有两个步进电机，一个控制X轴转动，一个控制Y轴转动， 电机的每一个正脉冲作为一个步进单位，转动一度。 基于msp430f6638的二维扫描系统。设计一个在X和Y方向，分别转动范围为-90度～+90度，实现一个二维扫描。 若扫描位置发现目标后，记录下位置坐标，并显示和发出蜂鸣声。-two-dimensional scanning system based on Msp430f6638
YZR500-DEDINGER
- YZR 500 motor DESIGNER design
test1_IO_INT
- atmega128的外部中断模板程序，设有指示灯提示功能。-ATmega128 external interrupt template program, with an indication lamp prompt function
test2_UART
- atmega128的串口模板程序，适合初学者直接使用，只需要修改少量的内容就可以完成移植-ATmega128 serial template program, suitable for beginners to use directly, only need to modify a small amount of content can be complete
test3_Timer
- 这是AVR单片机的定时器模板程序，程序简单不臃肿，适合新手使用-This is the AVR microcontroller timer template program, the program is simple not bloated, suitable for novice to use
test4_FLASH-PUART
- 这是atmega128调用45db161d的示例程序，本程序显示部分为特定模组，仅参考-This is the ATmega128 call 45db161d example program, the program shows that part of the specific module, only reference
test7_EEPROM
- 这是AVR的EEPROM读写程序，程序是测试通过的，能直接使用-This is the EEPROM AVR read and write procedures, procedures are tested, can be used directly
STM32L151CR_HuPo
- STM32L151RC 工程程序源码，包括UART、I2C、SPI等
Znc
- 使用MAPLAB编程，基于PIC16F877A单片机的智能小车单片机端程序，实现小车的前后左右走动。-Use MAPLAB programming PIC16F877A microcontroller-based Intelligent Vehicle microcontroller end procedures, before and after the car left and right to move around.