资源列表
GenericApp_Serial_NV
- 协议栈上通过Coor发送信息，End发送给Coor，Coor再通过串口发送给上位机-Send information on the stack by Coor, End sent to Coor, Coor then sent to the host computer via the serial port
DAC7611-AVR-Mega32
- dac7611 init by avr
ILI9481-LPC1768
- ili9481 init by lpc1768
ugui-LPC1768
- ugui lpc1768 window button suport
CC2511-USB-Dongle-Reference-Design
- CC2511蓝牙芯片的硬件设计参考.其中有很详细的天线设计说明和巴伦设计说明.同时还有其固件的开发源码-Hardware design of the CC2511 Bluetooth chip, which has a very detailed antenna design and the design of the
SmartUARTRT
- CC2540有并串口主从机的软件代码.可直接使用测试-CC2540 with and serial master slave software code.
BREATH-LED
- stm32的呼吸灯程序，结构化程序lajlfjlkajsdfjjlkafj-stm32 breathing light program, structured program lajlfjlkajsdfjjlkafj
sketch_aug08a
- arduino程序，PID算法实现MPU6050角度输出，这句话用来增加字数。-arduino program, PID algorithm MPU6050 angle output, this phrase is used to increase the number of words.
blink
- a blink code in ardu-pilot mega (2.6) platform
A_final
- 基于 TI公司的LDC1000 电感/数字转换器的非接触式金属识别系统，控制器仍然采用TI公司的TM4C123GH6PM单片机利用小车搭载，实现了定位。-Based on TI' s LDC1000 inductance/digital converter non-contact metal identification system, the controller still using TI' s MCU use TM4C123GH6PM car equipped to achi
SPI_FLASH
- STM32 flash Driver. DEVICE (TESTED) STM32F107VET
keyabeepaled
- 利用stm32f103vct6实现按键控制led和蜂鸣器-Using stm32f103vct6 button control led and buzzer