资源列表
keyboard
- 可以演奏的电子琴，51单片机，Proteus仿真-You can play the keyboard, 51, Proteus simulation
FSK_TxRx.pes
- Tx/Rx FSK This scr ipt sends a standard preamble and then switch to data transfer mode. This scr ipt allows the modem to synchronise to an incoming data stream that is preceded by a preamble.
BiQuad1_2_1k4-2k3_Test.pes
- BiQuad1-2 1k4 2k3 Test.pes. Set up the CMX865A Programmable Tone Detectors (PTD) for decoding the Ademco handshake and kissoff tones. This scr ipt can be used to test the response/de-response time and interrupt processing reqd.
LineStateDet.pes
- Determines bias voltage at switch on. Must be on-hook and snoop resistors disconnected. Once bias is determined, snoop resistors may read the line voltage. Relative changes in line voltage to bias are used to determine the line state. conta
Airtight.tar
- 测试台的工控程序，主要控制继电器，LED灯，以及分频器-IPC test bed program, the main control relay, LED lights, and a frequency divider
GPCSrc
- GPS Library To Access the GPS Locations.
GSMSrc
- GSM SIM300 program library. Can read sms, send sms, delete sms. compatible and tested with 8051-family need at least 300bytes of RAM. Used P89v51RD2
Make-LED-flashes
- 使与 P3 口的 P3.0 引脚连接的发光二极管闪烁-Make P3.0 pin connection port P3 LED flashes
emitting
- 8 个发光二极管 1、3、5、7 与 2、4、6、8 交替发光的例子-Eight light-emitting diodes emitting 1,3,5,7 and 2,4,6,8 alternate examples
Timer-controlled-LED-flashes
- 定时器控制的发光二极管闪烁.这里使用了 MSP430F149 芯片的 32768Hz 低频晶体振荡器作为时钟 源。-Timer-controlled LED flashes
LED-blinks
- 选择不同的时钟源，使 P3.7 连接的发光二极管闪烁。 （1）使用 XT2 时钟源，8MHz 频率，用定时器 A 分频，产生 1s 脉冲，使 P3.7 引脚的发光二极管闪烁。-Choose different clock sources, so P3.7 connected LED blinks. (1) using the clock source XT2, 8MHz frequency divider with the timer A, the pulse generating 1s,
display
- 使单片机MSP的P4 和 P5 输出口连接的数码管显示 1 和 2。-make the MSP microcontroller output port P4 and P5 connected digital display 1 and 2.