资源列表
C16
- 用DS1302及DS18B20+MAX6951设计的多功能电子日历牌-DS1302 and DS18B20+MAX6951 design with multi-functional electronic calendar card
lighting
- Keil uV4下基于ARM-LPC1768芯片的点灯程序-lighting procedures based on ARM-LPC1768 chip in Keil uV4
dp83848-with-lpc1768
- ARM芯片lpc1768、网口驱动芯片DP83848时的以太网通信程序-Ethernet communication program with ARM chips lpc1768 and drive chip DP83848
CRC
- 适用于使用C语言编程的各种单片机的数据的CRC冗余校验程序。-Applicable to the use of the various microcontroller C language programming data CRC redundancy check procedure .
dsPIC_ADC_10
- 此程序为dsPIC33FF128GP706的10位ADC的初始化程序已经AD数据采集程序。-This program is dsPIC33FF128GP706 10-bit ADC initialization procedure has AD data acquisition program .
dsPIC_ADC_12
- 此程序为dsPIC33FF128GP706的12位ADC的初始化程序已经AD数据采集程序。编程环境为MPLAB 8.85-This program is a 12-bit ADC dsPIC33FF128GP706 initialization procedure has AD data acquisition program . Programming environment for MPLAB 8.85
dsPIC_ECAN1Drv
- dsPIC33FJ128GP706A单片机的ECAN1的初始化设置已经滤波器设置程序。-dsPIC33FJ128GP706A ECAN1 MCU initialization settings have filters setup program.
dsPIC_time
- dspic33fj64gp706单片机的定时器1，定时器2,定时器4初始化设置，以及中断服务程序。-dspic33fj64/128gp706 microcontroller timer 1,2,4 initialize the setup program.
dsPIC_Uart
- dspic33fj128gp706单片机的串口设置初始化程序，可以方便地设置需要的波特率，串口1或者串口2.-dspic33fj64/128gp706 microcontroller serial port settings initialization process, you can easily set the desired baud rate, serial port 1 or serial port 2.
Verilog-Programming-specification
- Verilog 编程规范，讲述FPGA编程时应注意的问题。-Verilog Programming specification
pwm
- dspic33fj64/128gp706单片机的PWM脉宽调制输出初始化程序，可以任意设置占空比输出。-dspic33fj64/128gp706 microcontroller PWM pulse width modulation output initialization procedure can be arbitrarily set the duty cycle output.
lifesaver-080991
- controling of unmanned boat (small one ) using AVR micro controller and C programming.