资源列表
CCP-Test
- PIC MCU 18f4520 CCP test
PIC_CLOCK
- MPlab下一个pic单片机lcd电子钟的程序，按键实现时间可调-A lcd clock base on PIC ,which is able to set the time by buttons.
320x240YEJINGQUDONG
- 320*240点阵液晶模块驱动程序,控制芯片为SED1335-320* 240 dot matrix LCD module driver for the SED1335 controller chip
perpetual_calender
- 自己用51单片机实现的一个多种功能万年历，具备基本的日期，时钟显示，闹钟功能；同时还带有室温检测，亮度及异常温度报警等功能；液晶背光可自动调节，有夜间与白天两种模式。-Own a single chip with 51 calendar functions, with the basic date, clock display, alarm clock function but also with a room temperature detection, brightness, and ab
CSharp
- CSharp波形显示控件源码，用于单片机串口数据传输-CSharp Waveform Graph.use for MCU
c51ds1302lcd
- 基于C51的时钟程序，采用时钟芯片DS1302，以及12864LCD显示屏显示时间,实现精确计时。-C51-based clock procedures, using the clock chip DS1302, and 12864LCD display time.
CYUSB3014_schmatic
- usb3.0开发板原理图,有参考价值，能跑到200M-usb3.0 development board schematics
ClockLCD
- 利用stm8s单片机内置时钟控制LED闪烁-Single-chip built-in clock control LED flashes
8253
- 本实验使用8253的定时计数器2，GATE2接到开关K1上，CLK2接1MHZ的时钟脉冲，OUT2接示波器观测输出波形，并在数码管上显示“8253---C”。-The timing of the experiments using 8253 counter 2, GATE2 received on the switch K1, CLK2 clock pulses received 1MHZ, OUT2 connected oscilloscope to observe the output wa
Test2
- 实现led流水灯，使用ads编译环境，axd调试器，jtag-Led light water use ads compilation environment, axd debugger, jtag
E_FLASH_WR
- flash W25Q128读写程序，包括读寄存器，页编程，页擦除 单字节读写，多字节读写等模块-Flash W25Q128 to read and write procedures, including reading register, page programming, page erasing single-byte, speaking, reading and writing, multibyte, speaking, reading and writing module, etc
UART_arm10_ch
- 这是arm10上面的linux环境下的串口通信源程序,方便学习和调试-above the linux environment of serial communication source to facilitate learning and Debugging