资源列表
automaticAdjustment
- 本文提出了一种智能仪 表零点和满度自动校正的方法 ,给出了零点和满度校正的电路和软件框图 ,现该方法已经应用于实际中 ,并取得了良好的效 果。-In this paper, an intelligent meter zero and full-scale auto-calibration method gives zero and full-scale calibration of the circuit and software block diagram is that the me
PID-Temperature-Control
- 这是我的原程序，设计的硬件电路，上位机程序，希望对大家有帮助.温度控制-This is my original program, the hardware circuit design, the PC program, we hope to help. Temperature control
USART-8
- uart driver for drive at91sam7x256 uart.
i2c dm6437
- i2c example for dm6437
mobilsecurity
- this scurity for car and nice to you-this is scurity for car and nice to you
c_tester
- This is a small program that tests voltage drops on a Ford 6R80 transmission for correctness, using an ATMEGA168 and a reed relay matrix with some logic glue.
t2_Updata
- 嵌入式系统的一个实验程序，对学习开发嵌入式系统有很大帮助。-An experimental program of the embedded system, the development of embedded system are of great help in learning.
Tman
- Collection off IDC file for ida
Sensor
- Atmega8 Sensor Board
STM32_TIM_Example
- This the source code. MPU is STM32 of ST. It is the example for TIM of STM32.-This is the source code. MPU is STM32 of ST. It is the example for TIM of STM32.
COMAssist1.51
- 参考萧峰工作室的串口例程,使用mscomm 6.0编写,创新之处在于程序启动时自动检测并安装ocx控件,自动检测串口,单个文件方便使用,不需要手动安装ocx控件,另外也有许多细小功能的增加,如16进制自动过滤,设置参数的自动保存,相当稳定和人性化,界面布局参考了\"串口调试器 2002\",谢谢上面的两位大侠. 使用VC++ 2005编译,winxp home/pro测试,本人开发中长期使用. -reference to the serial routines, the use o
lm3s1138Flash
- 内容包括：（1）Flash简单擦写，（2）Flash当作EEPROM 以及内部闪存的介绍 源程序都是开发板配套的，包括整个工程-Include: (1) Flash simple erase, (2) Flash as EEPROM, as well as the introduction of internal flash memory are the development board supporting source, including the entire project