资源列表
YL-LPC2292_SCH
- 深圳优龙公司LPC2292开发板的原理图，PDF格式
M16C5MTimeAIO
- 瑞萨单片机的数据文件说明以及相应的数据说明-Renesas MCU data file descr iption and the corresponding data on
ucosto2812
- ucos在DSP2812上的移植，可直接下载到板子上-uCOS in DSP2812 s transplant, can be directly downloaded to the board on
DS18B20
- 基于MSP430F169单片机的温度传感器DS18B20的控制程序-Control Program of Temperature Sensor DS18B20 Based on MSP430F169 Single Chip Microcomputer
MGC3130-I2C_Message_Decoding
- mgc3130 microchip最新的手势感应芯片的C语言开发例程-mgc3130 microchip latest gesture sensing chip C language development routines
Acromag_Intro_TwoWire_Transmitters_4_20mA_Current
- Acromag Intro TwoWire Transmitters 4-20mA Current Loop.
LM5007QuickStartCalculator
- LM5007芯片参数计算软件。该软件只需要简单地用鼠标设置一下参数，软件将自动计算出合适的值。-LM5007 chip parameter calculation software. The software simply use the mouse to set the following parameters, the software will automatically calculate the appropriate value.
2410_NAND
- 优龙FS2410板NAND flash的读写程序，可实现往flash里读写数据
shuzuzhong
- 基于单片机51的数字钟设计，内容包括完整程序和仿真，以及根据设计过程写好的实验报告，可以参考-Digital clock design based on single-chip 51 includes complete program and simulation, as well as written lab report according to the design process, you can refer to
ILI9481P3.5
- tft3.5显示程序，驱动IC为ILI9481，可以显示红、绿、蓝以及灰阶色彩的显示。-tft3.5 display program, driver IC for the ILI9481, you can display the red, green, blue and gray color display.
The-touch-screen-test
- 功能：开机的时候先通过24C02的数据判断触摸屏是否已经校准过，如果没有校准，则执行校准程序，校准过后再进入手写程序。如果已经校准了，就直接进入手写程序，此时可以通过按动屏幕来实现手写输入。屏幕上会有一个清空的操作区域（RST），点击这个地方就会将输入全部清除，恢复白板状态。程序会设置一个强制校准，就是通过按KEY0来实现，只要按下KEY0就会进入强制校准程序-Function: the boot when the first through the 24C02 data to determin
msp430tuner
- Code for Guitar Tuner using strobers