资源列表
AT89C2051motorcontrol
- 用AT89C2051控制步进电机的程序 希望能有所帮助-Stepper motor control using AT89C2051 hope to help program
kumanda_saat
- MSP430F5308 RTC alarm sample code. Uart controlled RTC alarms setting. (Code composer studio V5)
ch7028
- CH7028 Full Datasheet Rev1
ANSharp128
- LED Messaging Waver ( using persistence of Vision to create letters and words) The circuit consists of LEDs tied from the 7 pins of portd to the first 7 pins of portb. The remaining pin (portb.7) can be used to switch to different messages or ch
17-SPI_Flash
- SPI-FLASH读写程序，单片机为stm8。-SPI-FLASH literacy program, microcontroller stm8.
wendu
- 温度+电压采集 使用的是LPC2132芯片-Temperature+ voltage acquisition using the LPC2132 chip
Baxis_gyroscope__IDG300_source
- 二轴陀螺仪IDG300源程序，主要实现姿态实现算法和温度补偿及校准,B-axis gyroscope IDG300 source, the main algorithm realize realize posture and temperature compensation and calibration
STM32-IIC
- stm32iicio口模拟程序，非硬件的，可以借鉴，但是个人推荐还是用硬件好！-stm32iicio port simulation program, non-hardware, you can learn, but good personal recommendation or hardware!
An_j1939
- Controller area network
os20
- This release of OS/20 is for use with both the OS-link based toolset, (ST20-SWC, release 2.0, on both Sun and PC platforms) and DCU based toolset (Osprey, release 2.0).
LCDd
- S3C2410下LCD驱动程序移植 及GUI程序编写-S3C2410 transplanted under the LCD driver and GUI programming
uart
- fpga 串行口 接收和发送程序，采用verilong语言编写-fpga uart ，receive and send include writed by verilog language