资源列表
KL05Z32VLC4_DMA
- 这个是飞思卡尔的kinetis L05的DMA例程-this is a demo for DMA of kinetis l05
C8051F
- C8051F的光盘资料，包括入门，CAN总线，MBUS总线，串口总线，LCD驱动，AD/DA等，
SD-for-lpc210x
- lpc210x 中对sd卡的基本操作程序 、初始化读写SD卡的硬件条件（spi接口和其他有用的管腿，如写保护）-lpc210x sd card in the basic operation of the program, read and write SD card hardware initialization conditions (spi interface and other useful tube legs, such as write-protected)
MMC_Fat32
- simple PIC program to read a MMC with FAT32 format using mikrobasic code and proteus for design.
LPC2103读写SD卡数据
- LPC2103读写SD卡数据，解压后根据pdf文件的说明，运行环境为IAR
Sample-code-1V3
- 富士通单片机设计更好，功能更稳定，这是介绍该单片机编程的样板代码。-Fujitsu microcontroller design better, more stable, This is the introduction of the single-chip programming boilerplate code
ADS12
- ADS(ARM DEVELOPER SUITE)集成开发环境的使用-Use ADS(ARM DEVELOPER SUITE) integrated development environment
STC12LE4052AD_flash_EEprom
- STC12C2052AD片内flash作为EEprom的测试程序 程序利用串口显示当前读或者写的地址，可以通过串口写入16字节数据，并读出验证 过程：正常启动后LED1长亮，按键1读取数据，按键2测试串口，读取前要保证有数据 否则等待串口写入数据。第一次写入读出后显示不正确（地址0x00为字符串结尾） 从串口发送小于17位字符串（开头一位不存，最后一位0X00结束标志）。单片机收到 后返回原值，第一位为保存的地址。读取数据时，返回第一位为读取地址本演示代码 仅针
AT91SAM7A3-BasicTools
- atmel公司生产的芯片at91sam7a3的源程序-atmel
pt-1.3
- This open source, event-drived, RAM constrained embedded system.-This open source, event-drived. RAM constrained embedded system.
STMS3
- 电子钟,用到串口,在LCD上显示时间。用C写得,即根据时间变化可以得出不同时钟线.-Electronic clock, use the serial port, the time displayed on the LCD. Written in C, which changes according to the time clock can draw different lines.
35_707
- nucleus plus source code