资源列表
LoopBack_Bios
- dspbios ccs 视屏回显 适合学习bios iom驱动-dspbios 视屏显示
ARM7
- NXP系列的ARM7（LPC3132）芯片的裸机驱动，包括gpio，定时器，串口，ad转换等-NXP series ARM7 (LPC3132) bare chip drivers, including gpio, timers, serial, ad conversion, etc.
W5200_TCP_and_UDP_SampleCode_v1.2
- W5200 Chip of WizNet TCP and UDP SampleCode v1.2
anjianxianshi
- 应用飞思卡尔单片机，通过逐行扫描法和程序反转法实现按键的LED显示。还附有单独的LED显示程序-Freescale SCM application, achieved by the progressive scan method keys and LED display program reverses the process. Accompanied by a separate LED display program
Ifps_PWM_160523
- 对称互斥PWM软仿真mutexPWM_simTest, 少走弯路直接打开运行软件仿真即可看到对称互斥PWM波形, 下载到哑STM32F10x系列芯片中就有波形，示波器验证通过.(Symmetric mutual exclusion PWM soft simulation mutexPWM_simTest, less detours, directly open the software simulation, you can see symmetric mutex PWM waveform, d
ILI9320DS_V0.51
- TFT LCD Single Chip Driver 240RGBx320 Resolution and 262K color Datasheet
MG245X_EVB_Rev1.2
- MG2455的开发板硬件图纸，包括bom清单，原理图-MG2455 hardware development board drawings
menjin
- 用新塘芯片N32950实现的一个门禁系统，涉及了中断，定时器，PWM，时钟等配置-this menjin system in xintang N32950 configue
GPS-BASED-DATA-LOGGER
- GPS based data logger using PIC16F8-GPS based data logger using PIC16F877
ADC
- 现代通信系统和测试设备常常需要尽快地将模拟信号数字化，以便在数字域中完成信号 处理。但是，为模数转换器(ADC)设计变压器前端电路很有挑战性，特别是在高中频(IF) 的系统中。本文总结了5 个设计步骤，以帮助开发出最佳的ADC 前端-The modern communication systems and test equipment often requires expeditiously the analog signal is digitized, in order to perf
lcdmenu3
- 这是用proteus做的基于51核的一个菜单仿真的程序开发环境keil 没有使用os在裸机上跑-Proteus do this is with 51 nuclear-based simulation of a menu of the program development environment does not use keil on os running in bare-metal
open_loop_fre
- 基于STM32的PWM波形发生，可按键调频，内含死区，死区时间可更改。-Based STM32 PWM waveform occurred, may be the key FM containing dead zone, the dead time can be changed.