资源列表
5.4-MENUP18B20PUART
- 多点温度采集系统，基于AT89S52单片机-Multi-point temperature acquisition system based on microcontroller AT89S52
inc
- 8051单片机的核心板启动程序 可移植性很好-51 setup
DTMFmicrosoft
- This piece of code used a 2051 atmel microcontroller to decode DTMF code after a call signal is detected.
dcmotorcontrol
- dc motor electronics design using proteus
MSP430F449_LCD
- MSP430F449 段码液晶驱动程序-MSP430F449 段码液晶驱动程序
vs1002d_adpcm_100
- VS1002D ADPCM RECORDING INSTRUCTIONS v 1.0 (C) 2004-09-23 VLSI SOLUTION OY This is a software package to patch VS1002d ADPCM recording capability. It is explained in VS10XX Application Notes, available at http://www.vlsi.fi/download/
UART_CC2530
- CC2530 UART通信 采用中断方式 2530验证可用-CC2530 UART
Ver0.03
- 保护模式下8259A芯片编程及中断处理探究，代码演示，请高手多多指教~-protected mode 8259A chip programming and interrupt handling inquiring, demo code, 19:56 exhibitions ~ Thank you,
g726
- G726 audio codec source
s3c2440-PWM
- 利用PWM来驱动蜂鸣器，脉宽从低到高，再从高到低，周而复始。我们还利用4个LED来指示频率的高低，最高时LED全亮，最低时LED全灭。-PWM to drive the buzzer, the pulse width from low to high to low again, and again and again. We also use four LEDs to indicate the level of frequency, the maximum full-bright LED low
ican
- ICAN总线通信原代码，具有自动检测，故障分离，通信速度最高可至1M-ICAN bus communication source code, with automatic detection, fault isolation, communication speed up to 1M
shumaguan
- stc89c51单片机使用1个定时器实现数码管0~9循环源代码-51 display