资源列表
TN9-hongwai
- 由TN9、52单片机、4位7段数码管、按键组成的基本红外测温仪的源代码。-From the TN9, 52 microcontroller, 4 7-segment, the key component of the source code of the basic infrared thermometer.
RS485
- MSP430 RS485 programming example
TestSht75
- ATMega128 + SHT75 + LCD
113172223bjdjKZSD
- 单片机步进电机控制程序 可以控制加速减速的程序可以正反转-Microcontroller stepper motor control program can control the acceleration and deceleration of the programs can be positive inversion
linux_7113
- it is the course code which using linux driver platform to drive saa7113 video decode IC. you also can refer it to develop your embed project.
uartlibrary
- This the USART library that can be used on AVR micro controller, it has functions for sending string and receiving strings-This is the USART library that can be used on AVR micro controller, it has functions for sending string and receiving strings
cc2530-test1
- 在CC2530基本实验的基础上改进的程序，程序经编译仿真通过。-In CC2530 based on the improvement of basic experimental program, the program is compiled through simulation.
Two-separate-button-digital-counter
- // 独立2按键控制2位LED共阳数码管计数器 // // 个位数码管接在P0端口； // 十位数码管接在P2端口； -//Buttons control two independent two common anode LED digital tube counter//// bit digital tube connected to the P0 port // ten digital tube connected to port P2 //
jianpan12864
- 4*4按键+12864显示 基于51单片机 亲测 好使-4* 4 keypad+12864 shows measured based on 51 single chip so that pro-
Pressed-key-controlling-switch-
- zigbee Pressed key controlling switch
T2-programmable-clock
- T2可编程时钟,基于单片机的时钟源码，方便于你的使用，压缩包中，包括所有生成文件。-T2 programmable clock, based on SCM clock the source code.
iic_stc
- IIC的模拟程序，可以在keil软件上直接运行-Very large IIC simulation program, KEIL software in the implementation