资源列表
BOOM
- 简易炸弹原理，仅作为娱乐，请勿用于不法道路-The simple bombs principle, only as entertainment, do not for illegal road
Shift_register
- Simulation usin Proteus an AVR Atmega328p and ShiftRegister to controller relays.
Uart_com
- 本程序为STC89C52与PC机超级终端通讯的实验程序 在PC机键盘上输入字符，单片机接收，并发送回PC机，显示在超级 终端；超级终端配置为：波特率为9600，数据位8，奇偶校验：无 停止位：1；硬件：无-This program is STC89C52 communication with the PC HyperTerminal experimental procedures on the PC keyboard to enter characters, single-chip
CC2530UART2Test
- cc2530 串口接收程序 中间有接收中断操作，结合datasheet调整波特率可直接使用-cc2530 serial middle of the receiving program receive interrupt operation, combined datasheet adjust baud rate can be used directly
51-555
- 用555芯片产生并输出等间隔连续脉冲、断续波脉冲、幅度调制脉冲三种波形发生电路以及电压和电流输出电路，通过通过单片机控制选择不同的治疗刺激脉冲序列的输出、控制治疗时间-555 chip generates and outputs interval continuous pulse the intermittent wave pulse, amplitude modulated pulse the three waveform generation circuit and the voltage
P1240Linek
- 基于PCI-1240运动控制卡的示例4-Linek
opb_wb
- opb_wb verilog code itis very good
Bulkloop
- CY7C68013的USB块传输 源码程序-The CY7C68013 USB block transmission source programs
COPIADOR-DE-MEMORIAS-EEPROM-24XX
- 24XX copier EEPROMs with MICROCHIP PIC16F628A microcontroller
AD10_ta
- msp430单片机的AD和TA程序，很优秀的代码-msp430 microcontroller AD and TA program
osciloskop
- This code is for atmega8. Project is describe in AVR studio. Output signal is transfer trough serial link to matlab terminal.
P4
- msp430 149，模拟输入，电位计连续可调输入，产生PWM。-msp430 149, analog input, continuously adjustable potentiometer input to generate PWM.