资源列表
fx2fw
- Cypress FX2 Slave FIFO implementation. USB 2.0 High speed mode 40MB/s
EMDB409_some_export_for_OrCAD
- em4095 AUTOCAD DESIGEN
IIC
- IIC模块，适应于不同平台，Accelerometer_Algorithm_MTK IIC Driver_Userguide。-Accelerometer_Algorithm_MTK IIC Driver_Userguide。
SJA1000
- 基于 SJA1000 的CAN 通讯 工程 实例-CAN projection based on SJA1000
Keyboard
- 基于单片机设计的电子琴，不仅有电子琴的基本功能，还可以播放系统自带的三首乐曲，更重要的是用户可以自制乐曲并可以断点保存。-Microcontroller-based design of the keyboard, not only the basic functions of the keyboard can also play the system comes with three music and, more importantly, the user can self-made musi
UART_arm10_ch
- 这是arm10上面的linux环境下的串口通信源程序,方便学习和调试-above the linux environment of serial communication source to facilitate learning and Debugging
E_FLASH_WR
- flash W25Q128读写程序，包括读寄存器，页编程，页擦除 单字节读写，多字节读写等模块-Flash W25Q128 to read and write procedures, including reading register, page programming, page erasing single-byte, speaking, reading and writing, multibyte, speaking, reading and writing module, etc
Test2
- 实现led流水灯，使用ads编译环境，axd调试器，jtag-Led light water use ads compilation environment, axd debugger, jtag
8253
- 本实验使用8253的定时计数器2，GATE2接到开关K1上，CLK2接1MHZ的时钟脉冲，OUT2接示波器观测输出波形，并在数码管上显示“8253---C”。-The timing of the experiments using 8253 counter 2, GATE2 received on the switch K1, CLK2 clock pulses received 1MHZ, OUT2 connected oscilloscope to observe the output wa
ClockLCD
- 利用stm8s单片机内置时钟控制LED闪烁-Single-chip built-in clock control LED flashes
c51ds1302lcd
- 基于C51的时钟程序，采用时钟芯片DS1302，以及12864LCD显示屏显示时间,实现精确计时。-C51-based clock procedures, using the clock chip DS1302, and 12864LCD display time.
CYUSB3014_schmatic
- usb3.0开发板原理图,有参考价值，能跑到200M-usb3.0 development board schematics