资源列表
KEY_IN
- 按KEY1键LED1亮，按KEY2键LED2亮。当按键松开，其对应的LED灯熄灭。-When press KEY1 then LED1 is on, and press KEY2 then LED2 is on. When the button is released, its corresponding LED is off.
keypad_lcd
- 基于8051单片机的简单实验程序，实现4*3键盘与lcd1602的通信。包括连接图。-8051 based on a simple experimental procedure, to achieve 4* 3 keypad and lcd1602 communication. Including the connection diagram.
adc
- This Program is for PIC18f4520 Microcontroller. It describes the internal adc interfacing of microcontroller, Developed in Microchip MPLAB
145lcd
- 51单片机制作的电子钟。用lcd显示,用proteus仿真的源代码-51 minutes single-chip electronic production. With lcd display, proteus simulation with the source code
Joc_cu_bara
- Well...these are 2 samples of using background worker! A very clear one is that one which shows a bar loading as well as the procentage in background!It is addressed to those who need a better insight of how backgroundworker works in visual studio!
UART0-
- 利用单片机语言，实现单片机串口与上位机之间的收发数据的功能-achieve the goal for receiving and sending the datas.
PWM
- IAR 下 AVR的PWM使用例程，使用PWM控制LED显示-IAR AVR PWM routine use of the PWM control of LED display
12864
- 用AT89C51产生正弦信号和汉字并在12864液晶上显示出来-AT89C51 sinusoidal signal and characters and displayed on 12864
10-12864
- 12864模块试验单片机c程序，希望对初学者有帮助！-12864 single-chip module test c program, hope helpful for beginners!
95110_template_clarinet_mb95f118-v12
- fujitsu 118 工程文件 寄出基础-95110_template_clarinet file
MINISTM32--LCD
- ALIENTEK MINISTM32 扩展实验6 LCD帧统计-ALIENTEK MINISTM32 extension experiments LCD frame statistics
zhongduan
- 用PIC单片机内部定时器0，作为16位定时器使用，并开启溢出中断。单片机的外部中断0引脚接开关SW2，并设置为下降沿的触发方式。单片机的UART接口工作于全双工异步模式，1个起始位，8个数据位，1个停止位，波特率为9600，并开启接收中断，与PC机通信。编写程序实现功能：SW2按键按下时，LCD上显示“Timer0 Start”, 定时器0开始工作，然后LCD上显示“Timer0 Working”,当UART接收到PC机发送的命令“P”时，定时器0停止工作，LCD上显示“Timer0 Stop”