资源列表
8255a---elevator3OK
- 这是基于51单片机的四层电梯系统的设计，用到4个直流电机和2个步进电机，还有8255A用于扩展IO口，可以正常运行停止。-This is by design of the four-story elevator 51 microcontroller-based system, used four DC motors and two stepper motors, and 8255A for expansion IO port, you can stop running.
CE145_I2C_Slave_120309
- i2c slave for pic controller
serialport2
- 用 52 模拟SPI串口接受程序，然后控制无线模块发送出去！饱含nrf2401的初始化！-SPI serial interface with 52 analog acceptance procedure, and then control the wireless module to send out! Full of nrf2401 initialization!
memory-read-for-51MCU
- 利用4个数码管给单片机附一个值，单片机读出该地址下的内存数值并且显示在数码管上。-The use of four digital tube to the single-chip microcomputer with a value, single-chip microcomputer read the address of memory numerical and displayed in digital tube.
PCB_jishudaquan
- 该文件是关于PCB制板技术大全，非常实用，学习后将会受益不浅。-This file is on the PCB system board technology Daquan, very practical, learning will be after the benefit.
PwmAd
- 针对Microchip dsPIC30f4011的PWM编程，C/C++例程-Microchip dsPIC 30f4011
tutorial12
- x10 power line communication is good,to short data communication over powerline.here rf tx and rx software in asm.
MMA7455
- mma7455是飞思卡尔公司的数字角度传感器，该程序已测试通过并在各种系统上使用-mma7455 is Freescale s digital angle sensor, the procedures have been tested and used on a variety of systems..
pwm
- 本程序简单的示范了如何使用ATMEGA16的定时器 AVR定时器的要点介绍 T0工作于CTC模式，输出1KHz/2KHz 50％占空比的方波 T1工作于快速PWM模式兼输入捕捉 T2工作于相位修正PWM模式，输出490Hz的8bit PWM波
key72903
- 此为周立功7290芯片的控制程序 应用于S3C44B0板子
C
- 电子时钟，有时钟，闹钟，秒表功能，可以调时，设定闹钟时间-Electronic clock
12864-18B20
- 基于51单片机+lcd12864+18b20的温度计程序，-Based on 51 single-chip+lcd12864+18b20 thermometer procedures,